Dk Verde June 18, 2018 The two questions that I just read ask about the rear cover unit on the whirlpool refrigerator model ED2GHGXMQ00. One answer says it is necessary for control of air flow, and the other answer says it is not necessary to have one attached. As it doesn't effect the proper operation of the refer, I realize the insulation is there for noise reduction. So is it safe and still efficient to operate with it removed?
1 Answer DK Verde, The cover for the unit must be in place for proper airflow and if it is not can cause airflow to be wrong and cause overheating issue of the compressor and not get rid of the heat on the condenser coils. Read More...
Bobie July 13, 2014 for Model Number 106-9542850 Kenmore Cold Spot Cover Unit 2171575 or 2188756 The Refrigerator Side of the Unit stopped Cooling. After looking over the unit, I discovered a large bild up of Dust around the coils at the bottom of the unit. I have a Refrigerator Brush and cleaned off the dust, then it began cooling once again. I decided to pull out the unit to clean in back and discovered the Cover Unit is loaded with Black Dust, and I believe needs to be changed out. The one on your Web Site does not show a Padding attached to the cover. Is the Padding Necessary? Thanks
1 Answer Hello Bobie, The insulation is only in place as a noise reduction measure. Just as a note, the cover is very necessary to direct air flow. Read More...