Justin October 26, 2016 for Model Number PAV5158AWW The top of the flume on my model there is wires for the ATC the part I want to order is not showing a place to connect the ATC Is there another part I need to order ?
1 Answer Barbara, The water flume assembly WP21001760 is located on the rear underside of the washer top assembly.( you will need to raise the washer top panel, using a flat blade tool or putty knife, to release the top hold down clips in the seam, between the front panel and washer top panel, after you remove power to the washer.) The flume fits flush with the top opening and is secured to the top by two(2) mounting screws. An inlet hose from the water mixing valve connects to the flume nozzle. Read More...
Mark June 29, 2013 for Model Number MAV3905AWW The Flume assembly is leaking and rusting the underside of the top lid. What are the two sensors for that are attached to the flume assembly? I was going to take the hose and put it into the tub and bypass the flume assembly? What do you think?
1 Answer Mark, The 2 sensors on the flume assembly are for the Automatic temperature control. You would not want to bypass the flume assembly. Read More...
Jeff December 09, 2012 for Model Number SAV405deww The water pressure while filling up is low. I have cahnaged the mixing valve but did not fix problem.
1 Answer Hello Jeff, You may want to check to see if there are screens on your hoses that may be clogged. If you changed the water valve and still getting slow flow then you should also check your home water pressure. Read More...
Tim S. May 13, 2011 for Model Number Maytag Washer - pav2300aww There is a small hose 1/8" runs from bottom of washer tub up through hole at top and attaches to something? What is the purpose of this tube and what is it suppose to attach small clip to? I cannot find anything on lid assembly or top of tub. Thanks Tim Simmons
1 Answer Hello Tim. It sounds like your talking about the pressure hose WP21001748. It is used to determine the water level inside the tub. It attaches to the pressure switch. Hope this helps. Read More...
Tim May 13, 2011 for Model Number pav2300aww This piece was not on our washer. Could you tell what this part does? Thank you.
1 Answer Hello Tim! The flume assembly WP21001760 is where the water comes in to the washer tub from the inlet valve. Hope this helps. Read More...