Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Refrigerator Ice Container Slide Rail by Whirlpool

Best Seller
Manufacturer Part
4.89 (64)
By: Whirlpool
Part Number: OEM18048696
Manufacturer Part Number: WPW10170835

This is a plastic glide rail that supports the ice container or drawer inside the freezer compartment, allowing it to slide in and out smoothly. It mounts to the interior wall or frame of the freezer section. Replace this part if the ice bin is difficult to pull out or push in, or if the glide is cracked, warped, or broken.

More
$207.95

IN STOCK
Ships Today Guaranteed
Add to Cart

Questions & Answers

For Whirlpool Refrigerator Ice Container Slide Rail (Part Number: OEM18048696)

1 Answer

Jason,

The door gasket should not need to be cut in order to fit on the dishwasher.

Read More...

1 Answer

Brad,

You can try to heat the gasket with a hair dryer but in most cases when the gasket stops holding it will need to be replaced.

Read More...

1 Answer

Terry,

Yes, the gasket should stop the leak but also check to ensure that the spray arms are not clogged or cracked.

Read More...

1 Answer

Mark,

When you pull out the tray, there should be a tab at the back of the glide that you would push in on and then slide the entire glide out.

Read More...
Tim P for Model Number KFCS22EVWH

I am trying to replace the glide (AP364480) that is attached to metal flange at the top of freezer and holds up the ice tray. The bearings came out of the glide so the entire piece must be separated from the metal flange and be replaced. It seems that there are 2 rivets through the broken glide, the flange and the the glide on the opposite side. How do I remove the entire assembly from the flange that it is attached to so that I can install your part. I know how to separate the part that attaches to the plastic tray, but I have to replace the whole glide assembly. How do I get it off the flange? Thanks very much.

1 Answer

Tim,

From what I can see, the only way to separate the flange and glide would be to drill out the rivets. The manufacturer does not list rivets to replace them but this is what is shows as needing to be done.

Read More...

1 Answer

Tim,

The rail is held in by a clip that you extend the rail out and there will be a hold that you push a screwdriver into to release the rail. You will then be able to replace the rail on the unit.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google