Samuel S September 02, 2016 for Model Number BR22TE Do you have a video to show how to replace the defrost heater on a BR22TE Amana
1 Answer Samuel, Unfortunately there would be no video or instructions available on replacing the defrost heater on the unit. You will need to pull the shelves out of the freezer and remove the rear wall. Then you will disconnect the heater wires. There will be a couple of screws that also hold the evaporator in that will need to be removed. Once removed you will need to rotate the bottom of the evaporator out being very careful to not kink the tubing. Just get it out enough to get the heater off the evaporator and install the new one. Read More...
D September 06, 2013 for Model Number AP4001947 We need a defrost element these dimensions or similar that runs on 240v.This one runs on 120v. Is there a part like this in your inventory?
1 Answer D, Unfortunately, we do not carry a 240 vac defrost heater. The only models that may have something like that would be an export model or a commercial unit. Read More...
Matt June 20, 2011 for Model Number 596.71103101 I'm troubleshooting the defrost system on my Kenmore 596.71103101. I measured 312 ohms across the terminals of the defrost heater at room temperature. I'm wondering if this is the manufacturer's value.
1 Answer Hello Matt. If the heater is showing resistance, it is good. You will need to test the thermostat WP10442411 for continuity. It should read closed when cold. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps.http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
1 Answer Hello Edward. You will need to use needle nose pliers to remove the clips. Unhook the front side of the clip from the evaporator first. Be careful not to punch a hole in the evaporator. Hope this helps. Read More...