William December 30, 2017 for Model Number KESH307HBS4 Front left dual element burner comes on both small and large surface area while selecting small only. Schematic on this page shows these infinite switches are items 21 from the parts list. There are four infinite switches to choose from on the list. Each has a different wattage rating. Which switch is the correct replacement for the front left dual burner?
1 Answer William, The dual infinite switch for the front left burner will be part number 8203536. Read More...
Yoast May 29, 2016 for Model Number KERC607HBS0 Dual burner not turning off correctly. Sometimes I have to shut it off twice for it to go off. Which switch do I need? Thank you
1 Answer Hello Yoast, You will need to order 8203536 for the dual element on the model provided. Read More...
Michael August 18, 2015 for Model Number kesc307hwh0 The dual burner on my electric stove top would not shut off. It would only glow for a few seconds and then turn off and repeat. I replaced the infinite switch but still having the same problem. Any ideas on what could be the issue?
1 Answer Hello Michael. It is normal for the element to cycle on and off. If it is not doing it properly, then you will need to replace the element. Read More...
Doug December 02, 2014 for Model Number KESC307BAL9 I notice that I have individual connections on the back of the 9751758 Dual Element, RR switch (Surface Element Switch 8203536). Yours has a connector block. To use your switch do I just use the comparable numbers/letters to do the connections?
1 Answer Doug, The infinite switch has individual terminals. You're referring to the video attached to the part diagram. Some ranges do have a pre-configured connector on the wire harness, most do not. Mark the wires with the letters or numbers as you remove them from the original switch, and attach them to the same terminals on the new switch. You'll be fine. Read More...
Bob November 19, 2014 for Model Number kesc300bwh11 The right rear dual burner only comes on hi there is not temp control.
1 Answer Hello Bob. Based on the information you provided, the burner switch 8203536 is bad and will need to be replaced. Read More...
Bob January 13, 2012 for Model Number kesc307hbs4 This is a replacement part and the org one is not the same...with the wires....How do I install this part on my appliance?
1 Answer Hello Bob. Look at the back of the old switch and the new switch 8203536. Make sure the letters are installed to the same post. Example L1 need to be on L1. The location of the terminal may have moved on the back of the switch from the original to the replacement. Hope this helps. Read More...
Dick S. December 16, 2011 for Model Number KitchenAid Range #KESC307GWH1 I purchased this switch for dualburner that only the smaller part was working. I installed new switch and now both parts do not work, although the indicator light comes on. During me reconnecting the new switch everything matched from old to new except that on the instruction sheet N - Brown wire was a Blue wire. Please tell me what is wrong.
1 Answer Hello Dick. Look at the back of the old switch and the new switch 8203536. Make sure the letters are installed to the same post. Example L1 need to be on L1. The location of the terminal may have moved on the back of the switch from the original to the replacement. Hope this helps. Read More...
1 Answer Hi Hope. The wiring diagram is in the control panel or in the storage drawer area for your unit. Thank you. Read More...