Eddie September 06, 2016 for Model Number JFC2070KRW My freezer is cold but, my refirgerator is hot please help.
1 Answer Hello Eddie. It sounds like you may have a defrost problem with the unit. Check and see if there is any frost build up on the evaporator coils in the freezer. If so, you will need to test the defrost heater and the defrost thermostat. They should read closed for continuity when cold. You can test this with a multi-meter TJMA-DMT3. I will include a link at the end to assist you how to use the multi-meter if needed. If both parts are good, you will need to replace the defrost timer. Once the problem is repaired, you will need to thaw out the ice on the coils before the unit will operate properly. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Frank May 03, 2016 for Model Number KFCS22EVMS8 How do you remove the damper cover from KitchenAid Refrigertor model KFCS22EVMS8?
1 Answer Frank, The louvered cover snaps and locks in place from the top. You may want to use a small flat blade screw driver or putty knife. Insert the tool at the top corners of the cover and press down to release the cover. Read More...
Rich March 06, 2014 I have a Kitchenaide dishwasher with W1031123B as well as W1031124B as ID. I need the screw in plug for the "jet dry" type reservoir. Can you help?
1 Answer Hello Rich. I do apologize but that is not a valid model number. If you open the door there should be a tag on the tub that will have model and serial number. Thanks Read More...
Charles July 03, 2013 for Model Number MBF2258wew1 Frost started forming on damper vent in refridge. Could you please inform me of what this actually controls or it's purpose? I am also noticing the temperature in my refridge not as cold as before and I am afraid of loosing my food. Do you believe it's the damper control switch? or could it be something else???
1 Answer Hello Charles. This is a cover for the damper. If it is frosting, either the evaporator fan motor may be running slow, or a seal or gasket is bad and allowing warm air into the cabinet on the unit. You will need to check and see where the issue is on the unit. Read More...
Jerry June 24, 2012 for Model Number MFD2561HEQ How do I remove damper cover insert, AP4079109? See two tabs...push in then pull down?? Don't want to break it.
1 Answer Jerry, you're awfully close, Press down on the tab, and pull out on the cover. Thanks Read More...