David October 29, 2019 for Model Number FET290 I successfully installed a new switch, p/n AP6014691 and while the orientation of the pins was different such that it did not align with the wiring harness as the original, I was able to mount the switch as it should be. It works fine except now it only turns the burner on high. Did I get something reversed or mis-positioned? Or is there another issue at work here. Thank You
1 Answer David, the wire position will need to be verified dependent on which position switch was changed. Another thing to check for would be another switch that may have failed and could be providing 120VAC while in the off position, or there could be a grounded wire. A wiring diagram will be sent to assist with this. Read More...
1 Answer Hello Mike. You will need to check and see if the bake element is bad on the unit. If it is good, then you will need to order and replace the control on the unit. Read More...
Dennis M July 22, 2015 for Model Number Ro702021 I did not see the micro switch for the indicator light. Mine clips in to the t-stat (infinite switch).
Ron July 20, 2011 for Model Number ket594 595 The existing control switch is held in with two screws. Will your replacement mount up and use the same knob?
1 Answer Hello Ron. Based on the model number you provided, R0702021 is the correct replacement switch. It should fit the unit and knob properly. Hope this helps. Read More...
Kevin S. April 23, 2011 for Model Number art661e what part number controls the temperature for the oven? Mine twisted off....
1 Answer Hello Kevin, the correct thermostat for this unit is Y0063416. The thermostat is no longer available, it was discontinued by the manufacturer. Thanks! Read More...