Rick Fillion February 28, 2017 for Model Number WhirlPool Dryer Don't know the model #. It shouldn't matter with this issue. One every repair person doesn't want to hear. In fact only one forum has addressed it. And people have spent 1000's for nothing. Cloths are in dryer, push the start button, after setting the drying mode where you want it. Dryer won't start. Barely touch the timer selector inward slightly and the dryer runs, let go stops, touch in runs. Do this a dozen 2 dozen times, and one will catch and the whole cycle will work fine. This is not a main control panel problem, it is not a themo problem, It is not a 100 dollar part problem, but everyone that's a pro is their first choice. This has to be a small contact problem. Either with OHMs a problem like inside a light fixture, where the ohms are either too low or high so the proper resistance isn't allowing the proper volts to get to where they are suppose to go. There has to be a contact part that is part of the internal section of the timer, that is not opening as it should. I am no electrician but experienced this with a couple light fixtures, and when I was shown how to use the tester for ohms, bingo. If I wanted to change the fixture socket and solder wires etc. I could have repaired. A new fixture cost 30.00. In the parts list there ais a couple parts that are a part of but separate of the selection dial. Why isn't this question even asked in these forums. One youtube video was taken down. I bet this was a 20.00 repair video. Makes me wonder how many people have paid for entire control boards, thermostats, entire starting knobs, and didn't get one installed but they paid for it. Why do I find in a couple forums that some people with these Whirlpool dryers have had the control board replace 2 to 3 times, then the relay thermostats to the motor and heater a couple times, all 100 plus parts, and continue to have a problem. Would one of you tech's who know what part I need please speak up. I would be willing to bet a Ben Franklin that this is a universal part that will fit most whirlpool and kenmore dryers made 10 years ago and up to now. At least ad this question to your list of questions, If I hold in on the selection dial everything works fine. What resistance part do I need? Yes I will unplug the unit before I change the part.
1 Answer Rick, You loose, This is not a $20.00 "universal" part repair. Based on your post information and description, you will most likely need the timer or control board to repair your dryer properly. The information indicates the internal components (timer contacts, timer cam wheel, timer shaft) are out of alignment and or damaged to the point they don't make proper contact and the dryer won't start/run. By pressing in on the dial, you force the cam wheel to align and activate the timer contacts and the dryer runs. If you have experience and knowledge of dismantling and repairing timers and control switches, and control boards, it's probably an easy repair. If not, you're probably going to create more problems than you had to begin with. In the old days(40-50 years ago) it was not uncommon to repair/rebuild a timer, but now a days the timers are "sealed" on the production line and are not repairable in the field. Read More...