Diana January 25, 2018 for Model Number Kenmore Elite 11044936203 How do I put back the dispenser parts after I took it apart to clean it on my Kenmore Elite 11044936203?
1 Answer Diana, If you are needing to put the motor and distribution lever back on the dispenser they will screw onto the back of the dispenser assembly. The motor will go on first and then the distribution lever will go to the top of the motor. Unfortunately any linkage we do not have information on. Read More...
Ed May 01, 2016 for Model Number MFW9700SQ0 The washing machine operates properly. When the cycle completes I opened the dispenser drawer and I see a large glob of soap still in the tray. I have it set properly for powder with the divider in the raised position. I don't seem to be getting any water in the dispenser to push the soap into the tank. Suggestions?
1 Answer Hello Ed. It sounds like the motor WPW10665207 is bad and will need to be replaced on the unit. You will need to check the dispenser motor on the unit. Read More...
Terry June 17, 2014 for Model Number ghw9400su0 I am getting a SUD code then it goes to code FO2. I had tore the machine apart. Cleaned all the drain hoses and the filter in the pump. Still got the two same error codes. Thinking about replacing the pump but, just wanted to know if this would correct the SUD error code that comes on before the FO2 error code? Thank you, Terry
1 Answer Hello Terry. Yes, it could be the pump. Here are the possible causes for the codes. Possible Causes / Procedure¦ If too much detergent was used:—Run the unit through a Rinse/Spin cycle.—Run a Normal cycle without adding any detergent.This should clear the unit of the excess detergent.1. Check the drain hose and make sure it is not pluggedor kinked.2. Unplug washer or disconnect power.3. Check wire harness connections to the drain pump,pressure switch, and Central Control Unit (CCU).4. Check/clean drain pump filter for foreign objects.5. Plug in washer or reconnect power.6. Check drain pump.7. Check the pressure switch.8. Verify CCU operation by running a Diagnostic test orany cycle. Read More...
Roy February 04, 2014 for Model Number GHW9150PW1 Duet Washer The washer will not add water while in the Rinse or Rinse\Spin cycles. It will Fault out with a flashing F & H error code. I have replaced the Pressure Switch and the CCU and those components did not fix the problem. Is it possible I was sent a faulty CCU or is there another part that is defective. Water is added in the Wash cycle.
1 Answer Hello Roy. It could be the cold water valve is bad and will need to be replaced. Also, make sure the water is not siphoning from the unit. Read More...