Steve K. May 30, 2016 for Model Number LSG7804AAE I am replacing the lid switch assembly. Do I also need to replace the fuse? I have a new fuse but can't seem to find where it goes. Thank you
1 Answer Hello Steve, You will access the fuse by removing the main front panel. The fuse will be in a fuse block on the left side as you face the unit in the harness. Read More...
Brian October 03, 2014 for Model Number LSE7804ACE How do I get to the lid switch assembly to replace it? Thanks.
1 Answer Hello Brian. Remove the access panel behind the washer top and the front panel of the washer. Now you can access and replace the lid switch. Read More...
Abe November 21, 2013 for Model Number 7804aae What is the difference between the 12001513 and the 12001514
Abe November 20, 2013 for Model Number lsg7804aae Water had stopped on my washing machine. I changed the inlet valve and no luck. I think it may be the lid switch. Only when I set the timer to spin, it spins. When I open the lid during the spin it stops. So my question is can the lid switch work for one and not the other. If not what else could remedy my situation. It stopped flowing water mid cycle.
1 Answer Hello Abe. Replace the lid switch assembly 12001513 on the unit. You will want to make sure the fuse is good on the unit also. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
David C. March 02, 2012 for Model Number LSE7804ACL Does a defective Lid Switch make the fuse go bad. In your last answer to me you stated that if the fuse was bad that the lid switch needed to be replaced. I did check the fuse and it is bad. I will have to order a new fuse and lid switch. Just asking so I can put all new parts on one order. thank you
1 Answer Hello David. Yes, the lid switch 12001513 is the reason for the blown fuse. Hope this helps. Read More...
Charlie July 11, 2011 for Model Number lsg7840aae I'm pretty handy. How do I find the lid switch in my washer? I have removed the front panel of the machine. I have pulled the washer out from the drier/washer stack. It looks like I might have to remove two hex screws in the front corners and lift the washer top to find the lid switch near the back, behind the tub. Is this right? Thanks very much.
1 Answer Charlie, I think you're working on a LSG7804AAE, the lid switch assembly is located in the right rear corner of the top. You'll need to slide the washer out from under the dryer assembly, and unplug the umbilical cord. Remove the front panel, and remove the 3/8 " bolt holding the top to the cabinet in the right front corner. On the right rear top corner, inside the large hole you'll see the 3/8 " bolt holding the rear corner to the cabinet,remove it. raise the top of the washer(from right to left/sideways). You will need to remove the 2 scews on the top, holding the switch assembly to the top, and slip the holding tab out of the slot, and drop the asembly out and down. reverse the procedure and tetst the washer operation. Good Luck. Read More...