Lou February 03, 2012 for Model Number KEMS308GSS0 Could you please instruct on the steps needed to change the AP3846617 bulb for the microwave oven of a KEMS308GSS0. Also, would this be the correct bulb. Thanks for your help.
1 Answer Lou, You do have the correct part number for the halogen,baseless cavity light bulb for the microwave oven. here are the basic instructions " 1. Disconnect the electrical power to the microwave/oven combination. 2. Remove the microwave oven from the oven cabinet) a) Unclip the wire retainer and remove it. b) Remove the lamp from the holder and remove the wires from the harness." Quite often, you don't have to remove the microwave. You can usually access and change the cavity light by removing the control panel. " 1. Disconnect the electrical power to the microwave/oven combination. 2. Open the lower oven door. 3. Remove the bottom screw from each of the two side trim pieces . 4. To remove the side trim, pull the bottom out approximately 2?, and slide the top down to free it from the control panel. 5. Remove the screws from the oven control 6. To remove the oven control panel, pull it out at the bottom, and lift and unhook it from the oven cabinet support at the top. 7. Pull the ground clip on the end of the green wire from the edge of the metal panel, and disconnect the wire connectors from the board. Set the panel face down on a padded surface to protect the finish." Good Luck and Thanks Read More...
Randy November 27, 2011 for Model Number KEMC378kss01 This is a microwave and oven combo, with the microwave on top. How do I replace the light in the microwave?
1 Answer Hello Randy. You will need to remove the microwave from the oven and remove the outer cover to access and replace the lamp WPW10440740. Once the cover is removed, you will see the lamp socket in the top of the unit. Hope this helps. Read More...
Charli October 12, 2011 for Model Number KBMS1454SBL0 How do you replace the bulb inside this model of microwave? Thank you for any advice you can give!
1 Answer Hello Charli. You will need to remove the outer cover off the microwave to access and replace the bulb WPW10440740. Once removed, you will see the clamp holding the assembly in place and once the clamp is removed, the old bulb will pull out and the new one pushes in. Hope this helps. Hope this helps. Read More...
Ri\Ichard Pickett September 16, 2011 for Model Number KEHC307KBL0 how to replace microwave light bulb
1 Answer Richard, In order to replace the cavity light on the microwave you will need to remove the oven control panel heres some help :1. Unplug oven or disconnect power. 2. Open the microwave oven door and remove the two flat-head screws from the bottom of the control panel frame. 3. Remove the control panel frame(pull out at the bottom and push the paneel up) and close the microwave oven door. To remove the cavity light: a) Disconnect the two pink cavity light LOAD wires from the microwave light transformer terminals. b) Squeeze the light wire clips, remove the ends from the slot in the chassis, and lift the light and remove it from the chassis. Good Luck and Thanks Read More...
Reg T. July 27, 2011 for Model Number Whirlpool RMC275PVS01 How do I proceed to replace the light bulb -I think it is part no: AP3846617 for the Whirlpool Microwave RMC275PVS01
1 Answer Hello, yes the correct bulb is part number WPW10440740. To replace bulb: Before replacing, make sure the oven is off and cool.1. Disconnect power. 2. Turn the glass bulb cover in the back of the oven counterclockwise to remove. 3. Turn bulb counterclockwise to remove from socket. 4. Replace bulb and bulb cover by turning clockwise. 5. Reconnect power. Thanks! Read More...
Chris March 25, 2011 for Model Number KEMC308Kss01 So, I have to pull out the whole unit to remove the outer cover to access the light bulb for the microwave? Thanks
1 Answer Hello Dean. To replace the light bulb in model KBMC147HSS03, you will need to remove the outer cover of the unit. It is located on the top of the cavity. Hope this helps. Read More...
1 Answer Hello Mike. You will need to remove the outer cover to replace this bulb. Hope this helps. Read More...