Mark August 25, 2014 for Model Number LTE6234DQ2 I have the stackable whirpool washer/dryer, and have a leak in the front. The question is, how do I get the cabinet off to see what is leaking?
1 Answer Hello Mark. Remove the panel above the washer lid by removing the screws. Then tilt down and lift up. Next release the 2 retaining clips and slide the top of the washer off the unit. Remove the 2 front panel retaining screws and remove the panel. Read More...
Eugene April 27, 2013 for Model Number Part Number: AP2911910 Made by: Whirlpool Hello, I am trying to open up the washer part of a combo unit, Whirlpool Thin Twin. And according to research, I just need to get these clamps(?) off to slide the top part of the washer off, and open the front panel. Part Number: AP2911910 Made by: Whirlpool However, I tried to snap these off in every possible way, but no lock. I was wondering if you had any tips to take these off, or even images of the part shot from different angles. Thank you,
1 Answer Eugene, To properly assist you we will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Peter November 08, 2011 for Model Number LT5000XVW0 How are the Top Front Locks (WHIRLPOOL Lock, Top Front, Part number AP29119100)released to open the washing machine cabinet front panel on the Whirlpool Thin Twin Washer Dryer Laundry System?
1 Answer Hello Peter. Remove the two screws securing thetransition panel to the unit. Tilt the transition panel down and pull itstraight out. Remove the two screws located behind the washer top. Pull the washer top forward to disengage the top locks WP345670. Disconnect the washer lidswitch harness. Lift the washer top off the unit. Remove the two screws from inside the top of the washer front panel. Lift up on the front panel to release the catches near the bottom of the panel andremove the front panel. The washer components can now be accessed. Hope this helps. Read More...
Sonia F. October 26, 2011 I have Kenmore front loaders . I am trying to secure the pedestals I purchased seperately to the washer and dryer. I will need a clamp for this. Can you please tell me what you have that I can use?
1 Answer Hi Sonia. We will need your exact model # to assist you. These models need the exact hardware kit for the pedastill's. Thank you. Read More...