Customer Questions and Answers for Lp Conversion Kit (Nat To Lp) by Whirlpool

Becky, you'll need four orifice which are included in the LP conversion kit part number 814547. Thanks.

Hello Rob, You will need to order kit number 814547. This kit has all four orifices. All you will have to do after installing these is to flip the stop under the brass nut on the gas valve, back the hoods off about 1/2 turn from bottomed, (brass part directly under the end of the burners in the bake compartment), and possible adjust the air shutters in case you have excessive yellow tipping.

Christina, the conversion kit listed for the given model is part number 814547. Thanks!

Gustavo, the LP conversion kit listed for your model is part number WPW10286688. You'll use the same regulator just flip the pin on the regulator to LP. Adjust the oven orifices. Thanks.

Paul, according to your appliance model number the LP conversion kit needed is part number 8273175. Make sure to flip the regulator to LP and adjust the oven orifice. Thanks!

Richard, the conversion kit is part number WP98013676. Conversion kit includes oven orifice. Thanks.

Dennis, The orifices on the oven bake and broil will need to be tightened all the way down and close off the air shutters. This is the way to convert them to LP. You may have to make minor adjustments to get the flames blue on the air shutter.

Kaiti, There is not a kit for converting the unit back to natural gas. The orifices that you would need have been discontinued by the manufacturer with no replacement.

Stephen, The model number you supplied is incorrect or is a partial model number. In most cases, Whirlpool Gas Ranges have adjustable bake and broil orifice(s). " Oven burner: Use 1/2" combination wrench to loosen the orifice hood away from pin (approximately 2 to 2-1/2 turns). The burner flame cannot be properly adjusted if this conversion is not made." It's not necessary to remove the burner assembly, in most cases and remember to open the air shutter on the burner full open, then fine tune the fuel air mixture until you have a double blue flame on all the openings.

Hello Fred! To convert your unit to LP you'll need to order LP conversion kit part number WPW10032010. This kit will include the four orifices for the top burners and the orifice for the oven burner. Flip the pin on the regulator to LP. Thanks.