Elmar February 22, 2017 for Model Number WTW5300SQ0 You mention removing the connector lugs from the molex plug for the lid switch - how do these come out? Back towards the wire harness or out the front towards the lid switch? and where is the small screwdriver inserted to get the retainer tab to move? thanks.
1 Answer Elmar, Disconnect the wire harness from the lid switch connection, look on the inside of the harness connector, each "pin" should have at least one tiny tab sticking up and against the inside of the plastic connector. Use a small jewelers,flat blade screw driver and press down on the tiny tab and pull the wire out the back of the plastic connector. Repair/replace the parts needed, use the same screwdriver to pry the tiny tab back up into position and re insert the wire from the back side of the connector, until it clips and locks in place. Read More...
Doug Oneil June 19, 2015 for Model Number WTW5540SQ0 Looking for a terminal part number for the lid switch connector AP3131785. I need 3 terminals. Center one burned and melted the connector. Not looking to purchase a $100 cable.
1 Answer Doug, The manufacturer does not provide a part number for the terminal that goes into the connector for the lid switch. Unfortunately this will not be information that we have available. Read More...
Ray March 21, 2015 for Model Number RAX4232PQ0 I just ordered from you connecter #ap3131783 for lid switch. My question is how do I get push pins out of old connector?
1 Answer Ray, To get the pins out of the connector will require a small blade screwdriver in which you will need to release the tabs that hold the pins in place. Read More...
Chrissy September 01, 2014 for Model Number TAWS700EQ1 I need the switch that goes under the lid but this one doesn't look quite the same. Will it work anyway?
1 Answer Hello Chrissy! The lid switch listed for your model is part number 3949247V. Thanks. Read More...
Brian February 19, 2012 for Model Number rtw43405q0 My lid switch burnt on my roper washing machine. I am going to replace the lid switch and the terminal receptical. I cut the wires, because the plastic was melted on the push terminals. However the terminal receptical does not have the push pins provided. Where can I find some push pins to comeplete my project?
1 Answer Brian, the push pins are not available separate from the wire harness 3958082. Thanks. Read More...