Henry November 01, 2022 for Model Number KitchenAid KEBS207SSS04 Oven KitchenAid KEBS207SSS04 Double Wall Electric Oven that does not heat up, bake or broil on both ovens. Because it happens on both ovens, I assume that it is not the bake, broil or thermostat. I have replaced the thermal fuse on the upper oven as well as the control board, but the issues remain. What possibly my next step to troubleshoot this issue? Thank you,
1 Answer Henry, Thanks for the question!!! You will want to start by verifying the incoming power to the oven is 240vac. If that is good and you have replaced the thermal fuses it would likely be the control board. You can verify by checking for voltage to the element when in bake mode. Read More...
Realcris December 15, 2012 for Model Number KESC307HBTO WOULD RELAY PART #9751948 KEEP OVEN AND CONTROLS FROM WORKING.
1 Answer Realcris, No, the doubler relay would not affect the control or oven, and keep them from operating. The place to start is the ambient thermal fuse WP9759944 located on the front of the cooktop burner box, behind the control panel, if it has an "open" circuit, power to the control board is eliminated and the controlm and display won't operate. Read More...
Realcris December 15, 2012 for Model Number KESC307HBTO HOW CAN YOU TELL IF RELAY PART # 9751948 IS BAD ?
1 Answer Realcris, You'll need to use a multi meter TJMA-DM1. With the meter set for the lowest resistance reading, when you place the meter probes on the small terminals, there should be a resistnce reading no resistance (000) or infinite resistance would indicate a faulty relay coil. When you apply the proper voltage across the two small terminals, the coil should activate and there should be a "closed" circuit across the two larger terminals. You'll need to remove the wires from the terminals when testing for resistances, so be sure to remove power to the range when testing in the unit or "bench test"(out of the range) the relay. Read More...
Willie March 08, 2011 Will the relay doubler cause the oven not to heat up when turned on, or should I replace the control panel board. The problem is when the oven is turn on it jumps to low and stays there never heating up.
1 Answer Hello Willie. The relay you are asking about is for the convection fan motor. You will need to check and make sure you have 240 volts coming to the oven. If so, then you will need to replace the clock. 3191106 Hope this helps. Read More...
Willie March 08, 2011 Will the relay doubler cause the oven not to heat up when turned on, or should I replace the board?