Dj July 16, 2019 for Model Number MDC4650AWW I purchased a new inner door panel from you (part number AP6009893) for my Maytag portable dishwasher (MDC4650AWW) because it was leaking and the bottom right corner was cracked on the old one. I appreciate that you carry parts for this dishwasher and your videos make installation easy. My issue is, there are two holes on the outer edge of the door where the screws do not tighten completely, they spin. I tried moving the screws around and no matter which screw I install into those particular holes they do not tighten completely. I have considered buying new screws but I am concerned the result will be the same. Also in your video, the screws across the top edge of the inner door were longer but all of the screws in my dishwasher were the same length. Are the longer screws available for my model?
1 Answer DJ, based on the information provided, it seems like the section that the screw goes into has a stripped out section or a section that could have bent. If it has been stripped out, a wider screw can be attempted but it would not be a guaranteed fix. If there is a bend in the screw port, then it can be attempted to correct it. The only sure way to correct the issue would be to replace the panel 6-917695. Unfortunately, the manufacturer has discontinued the panel and it is no longer available. Read More...
D.J. July 15, 2019 for Model Number MDC465135 Thank you for carrying parts and supplying videos. I just replaced the inner door of my dishwasher and everything went well except two of the screws do not tighten, they spin, and do not pull the door down tight. The screws do not seem stripped. I am concerned about leakage.
1 Answer Hello D.J., I'm sorry but we will need to ask you to please post a new question including the verified model number from the units' I.D. tag since the one provided will not come up for us as a valid model number. Thank you for your patience and understanding in this matter. Read More...
Sam April 26, 2013 for Model Number DU2000V Hi, can you tell me the part number for the screws which fasten the chassis to the undercounter? Also, our thic majic chef didn't come with any form for the kick plate or the adjacent access plate. Like to damper things down a bit. Does Whirlpool make an equivalent? Thanks!
1 Answer Sam, We do not have a part number for the screw to attach the unit to the cabinet. A flat head Phillips screw about 1/2" to 3/4" would work. There is not a dampening pad for the kickplate that will work for this model. Read More...
Carl Z. September 10, 2011 for Model Number MDBF750AWB What type of screw is part number ap4293134? Thanks, CZ
1 Answer Hello Carl. The screw WPY912620 is a torx head plastic screw. We do not have the thread sizes, you will need to contact the manufacture for those. Hope this helps. Read More...