Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Washer Tub Ring Splash Shield Assembly by Whirlpool

Best Seller
Manufacturer Part
4.89 (64)
By: Whirlpool
Part Number: OEM18037026
Manufacturer Part Number: WP8271956

This is a plastic splash shield assembly that sits on top of the washer tub, forming a seal between the tub and the outer housing. It helps prevent water from splashing out during the wash and spin cycles. Replace this part if you notice water leaking from the top of the tub area or pooling underneath the washer during operation.

More

Questions & Answers

For Whirlpool Washer Tub Ring Splash Shield Assembly (Part Number: OEM18037026)

Connie for Model Number WhirlpoolGSW9650LWO UltimateII washer

I have been thinking about buying a new washer, but other than a very rusty stained splash guard (due to iron in the washer) and possibly a new mixing valve, the washer is fine. I'm thinking to invest in parts. I can find a video on replacing the mixing valve but have no idea about splash assembly. I'm a 74 yr. old female, but I am able to do a lot of my own repairs or can get some help if necessary. #'s on the present rubber 022335 827156 PUC 3 3 It is one continuous piece and the piece that shows is about 2 inches. Your part has the same 827156 # but looks a little different. Please advise. I would love to save the $800., Most of the new washers are too deep for my space. Thanks much...

1 Answer

Connie,

This shield WP8271956 would be the correct part number for your unit. To access and replace this you would want to remove the cabinet. To remove the cabinet you would remove the screw on the back corner of the control panel ends. Once you remove these screws you will rotate the control panel from the bottom forward and up. Under the control panel, there will be 2 clips that you will use a flat blade screwdriver to pop loose. Once loose and the lid switch disconnected you can then lift from the back and slide the complete cabinet off. Once off lay the cabinet down to access the shield to replace. With the cabinet off you can also replace the valve.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google