Mark R February 22, 2023 for Model Number 110.29822801 Good Morning. My washer does not drain completely after the rinse cycle. It does however, drain completely after using the extra rinse cycle. Thanks for your help.
1 Answer Mark,It is possible that you have a small blockage causing a slow drain so all the water doesn't drain out. When the tub is empty remove the outer shell and the drain pump will be right in front under the tub. Remove the hoses with towels handy for leaking water and make sure the drain pump is clear. Read More...
Mike January 07, 2020 Kenmore series 80 heavy duty will only rinse in hot water but will wash in cold water. I was told I need part #AP6013545 is this correct?
1 Answer Hello Mike,this part does control the water fill temps, as long as the fill hoses are correctly installed then yes this part should correct the problem. Read More...
Buel December 08, 2017 for Model Number MVWC6ESWW1 My washer begins agitating before filling, it also is spraying water about 20-30 seconds before the spin cycle ends leaving clothes that were once dry upon checking to a big soggy heap.
1 Answer Buel, This issue would most likely be caused by the auto temp switch which is part number WPW10248240. Read More...
Brian October 28, 2015 for Model Number MVWC6ESWW1 Washer is agitating before it fills. What is the actual part name (switch/sensor) I have to look for?
1 Answer Hello Brian. It sounds like you will need to order and replace the temp switch WPW10248240 on the unit. Read More...
Anna November 23, 2014 for Model Number MVWC6ESWW1 Tub will not to fill with water even though the spin cycle is still working? Hoses and screens are clean.
1 Answer Hello Anna. It sounds like you need to order and replace the temperature switch WPW10248240 on the unit. Read More...
Apache August 27, 2013 for Model Number 28822801 Just got this washer Kenmore 800. Everything is working ok but the level on the loads . No matter what I choose, I end up with a full load.
David February 26, 2013 for Model Number MVWC6ESWW1 Machine will not fill to selected water level, and when it finishes, it starts filling again after final spin.
1 Answer Hello David. First off, this is an auto fill model. No matter the level selected, it will only fill to the level needed. If you raise the lid, then it reset and fills to full load. Also, raising the lid will damage other parts and has done so in this case. You will need to order the temperature switch WPW10248240 and the timer WPW10243947 to repair the unit. Read More...
Paul L August 02, 2012 for Model Number mvwc5esxw0 When this part is not functioning correctly, can it cause the tub not to fill with water even though the spin cycle is still working?
1 Answer Hello Paul. No, based on the information you provided, it sounds like you may have a bad sensor switch WPW10248240 in the unit. It will prevent the unit from filling, but work in the spin cycle. Read More...