Mike November 02, 2023 for Model Number LSQ9550PW3 Is there a way to test the switch to make sure that it is the reason that I am getting just cold water?
1 Answer Mike, You can this switch for continuity. Check the tech sheet to see which pins is for the hot and go across the 2 for continuity. No continuity would indicate the switch is is bad and will need to be replaced. Read More...
Scott November 02, 2023 for Model Number LSQ9550PW3 My washer will not fill with hot water all I get is warm water if I replace the temp. switch will that resolve my issue?
1 Answer Scott, Test the switch and see if there is continuity when you place it on the hot setting. IF there is not then this will be a faulty switch that will need to be replaced. Read More...
Mike November 02, 2023 for Model Number LSQ9110PW2 My washer will not fill at times and at times it will fill just a little bit. Would the temp. switch cause this?
1 Answer Mike, Check the water valve for clogs where the water comes in and if it is good then this could be a pressure switch or water valve that is faulty. Read More...
Ed January 27, 2013 for Model Number lsq9110pw2 Water spits and spudders on fill and at rinse time tryed new valve at where hoses hook on back of washer but that was not it so do you think it is the switch temp item #35.
1 Answer Hello Ed, You will want to check voltage to the water valve. Check to make sure that you are getting a constant 120 vac. The most likely cause of failure would be the ATC switch WP8564139. Read More...