Skip to Content
  • 2 Day Quick Delivery! 2 Day Quick Delivery!
  • 365 Day Return Policy! 365 Day Return Policy!
  • 15 million satisfied customers 15 million satisfied customers
  • Over 2.1 Million Parts In Stock Over 2.1 Million Parts In Stock
  • Repair ForumFree Tech Support!
  • Google Trusted Store Google Trusted Store

Customer Questions and Answers for Washer Water Level Pressure Switch by Whirlpool

Best Seller
Manufacturer Part
4.89 (64)
By: Whirlpool
Part Number: OEM18017292
Manufacturer Part Number: WP21001554

Fix washer overflowing or not stopping fill cycle. This water level pressure switch senses tub water and signals control to stop filling. DIY repair.

More
$118.53
Compare At:
$141.05
You Save:
$22.52

IN STOCK
Ships Tomorrow Guaranteed
Add to Cart

Questions & Answers

For Whirlpool Washer Water Level Pressure Switch (Part Number: OEM18017292)

1 Answer

Hello Clamsteam, you would need the water level switch located in the control panel, part WP21001554, You may also want to replace the airline tube at same time part WP21001748 Drain out all water from tub prior to replacing these parts.

Read More...

1 Answer

Hello Traderstick, I'm sorry but we do not have the capability to ship outside the U.S. at this time. Thank you for your patience and understanding in this matter.

Read More...

1 Answer

Hello Joe. We will need the serial number of the unit to help you with the part needed. Thank you.

Read More...

1 Answer

Timothy, To access all of the internal components, you need to raise the top panel, and remove the front panel. Use a putty knife or similar thin flat blade tool. Insert the tool into the seam between the front panel and the top panel approximately 3 inches in from the cabinet / top panel corners. Press in on the tool to release the retainer springs, and lift up on the corners of the top to release and raise it. Remove the two 5/16" hex head screws holding the front panel to the cabinet cross brace, pull the panel out towards you at the top, and lift the lower part of the panel up and off the retainer clips attached to the base. You should find the air dome hose/tube attached to the tub outlet in the right rear corner of the cabinet.

Read More...

1 Answer

Hello Lynda. On the back of the switch the wires go to terminals that are marked. You match the old to the new switch. Grey to 1. Light blue to 3 and Orange/Purple to 2.

Read More...

1 Answer

Hello Larry. Sorry, the part number you provided 20052800, is not a good part number. This may be a manufacturers number, but is not a valid system number.

Read More...

1 Answer

Hello Wilma! No, water level switch WP21001554 is not listed for your model. Unfortunately, the pressure switch listed for your model, part number 207364, has been discontinued with no further replacements or cross references available and our company is unaware of any other available sources. Sorry about that!

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • Over 2.1 Million Parts In Stock Over 2.1 Million Parts In Stock
  • 2 Day Quick Delivery! 2 Day Quick Delivery!
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Google Trusted Store Google Trusted Store
​