Memnoch March 20, 2014 for Model Number 110.86873100 Does this Timer also come with the Resistor, or is it separate??
Spotshot November 20, 2013 for Model Number 110.86873100 My older Kenmore dryer won't shut off. The timer works perfectly (heats and cycles) except when it get's very close to shutting off, it won't move any farther. The dryer keeps running in the cool down cycle until I turn it off manually. I tried a new timer and it did the same exact thing. I installed a new timer # 696876 and a new cycling thermostat. What next? Thanks
1 Answer Spotshot, With the timer being replaced already with the new resistor and the cycling thermostat then the only other thing that that could be the issue would be a bad centrifugal switch on the motor causing this issue. Read More...
David November 12, 2013 for Model Number 110.86873100 Hi. My dryer was in a state where the drum/fan motor would not run and the heater would stay on full blast whenever the timer was on. I changed the thermal fuse and now the motor works. However, the heater does not turn off in response to the door switch or anything else so long as time remains on the timer. The heater will only turn off if I put the timer in an off position. I checked the thermal cut fuse and that seemed fine. Could the problem be the timer unit?
1 Answer Hello David. The heater is grounded and is touching metal. You will need to replace the heater on the unit. Read More...
Wayne February 26, 2013 for Model Number 11086874800 Where is the resister located on this dryer in relation to the timer ?
1 Answer Wayne, The resistor will go between the two terminals that have an R next to them. One is RH and the other RS. Read More...
Koan September 17, 2012 for Model Number 110.86673310 Dryer runs, works, won't shut off at end of cycle In line resistor measures 22M Ohm rather than 4.050 to 4.950 k Ohms How can I tell if it is just the resistor or resistor AND timer other than replacing the resistor first??
1 Answer Hello Koan. Based on the information you provided, it sounds like the timer 696876 is bad and will need to be replaced. Read More...