John January 21, 2017 for Model Number 106.8750980 SN S54220440 Defrost timer is bad. I got a new timer from you. I do not have the original wiring diagram. Where does the black wire on the new timer go? Instructions say very important to put on the right pin to run correctly. Thank you
1 Answer Hello John, You should install the black jumper lead on the defrost timer on terminal number 1 for normal operation on the model provided. Read More...
Dave January 18, 2017 for Model Number ET1FTKXKT02 Whirlpool - I bought a replacement defrost timer to replace the original one, the new timer has a black wire, I have the original wiring diagram but it is too small to read. I just need to know if the black wire goes on number 1 or 2 at this point. Thank you.
M.W. January 17, 2017 for Model Number ET21DKXDW05 Purchased the defrost timer but not sure which terminal where the black wire should go to! (Whirlpool et21dkxdw05)? Thanks, MW.
1 Answer Hello M.W., You will need to place the black jumper lead on the terminal marked "1" for the model number provided. Read More...
Gary January 16, 2017 for Model Number whirlpool# ET8CHMXKQ02 Thermostat turned off, frig plugged in lights come on when door opened..trips GFI when you turn up dial for temp ..Would that be timer-defrost bi-metal or heater? or all the above..your help would be welcomed...thank you..Gary
1 Answer Gary, If the fans try to come on when the unit is plugged up then this would be more likely that the compressor has a short in it. If the fans do not turn on then the timer would likely be the issue. Read More...
1 Answer Hello Steven. You will need to put the wire onto the number 2 terminal of the timer. Read More...
Ac Fong December 31, 2016 for Model Number IS25CFXTQ01 Have a side by side Ingles IS25CFXTQ01, do I use the extra wire to 1 or 2?
Mannyg December 21, 2016 for Model Number RT14DKXSQ00 No schematic for this Roper what version of defrost does it have? continuous, version 1 or version 2? thanks MG
1 Answer Hello Manny. You will need to place the black wire onto terminal number 2 of the defrost timer. Read More...
Jeff December 03, 2016 for Model Number KTRS22MJWH01 I have replaced the defrost timer not sure where black wire goes, no schematic. Seems to be defrosting to much. thanks!
Rah November 21, 2016 for Model Number ET21PKXGT03 I am purchasing defrost timer ap5985208 for whirlpool et21pkxgt03---can you tell me which terminal the black wire goes on, I have no wiring diagram----thanks
Confused November 21, 2016 for Model Number ET21PKXGT03 I have no wiring diagram---I need ap5985208---- which terminal does the black motor wire go to?????
1 Answer Confused, The black lead wire will go on terminal labeled number 1 on your unit for part number W10822278. Read More...