1 Answer Hello, We will need your model number to answer this for you. You can check your lid switch to see if it is bad. Thanks! Read More...
Alex February 19, 2011 I bought this part (483212) to replace the part 945514 (listed below). Unfortunately, the old part has extra wiring on the side that does not exist in the new part. Can you please help to figure out the wiring? Thanks,
1 Answer Hello Alex, This answer was located on our Repair Forum, this is a free service in which technicians will assist with answering repair questions for our customers. Please use this link to assist in your repair. http://forum.appliancepartspros.com/refrigerator-freezer-repair/175363-whirpool-timer-defrost-replacement.html and http://forum.appliancepartspros.com/refrigerator-freezer-repair/4221-freezer-fine-refrigerator-too-warm-101.html. Hope this Helps! Read More...
Guest February 17, 2011 The leads going to my timer have 2 wires for each connection, they are 1-black 2-pink 3-red and 4-orange. I believe this is wired for a cumulative timer is that right? The old part did not have a motor lead wire but if I understand the procedure choices this wire should be attached to the #2 terminal. Is that also correct? The reason I am asking is because after running for almost 24 hours my Unit does not appear to be getting very cold.
1 Answer The black motor lead will need to be put onto #2. This is a cumulative run system. Read More...