Customer Questions and Answers for Timer by Whirlpool

Hello! According to your model/serial the timer used on your appliance is part number WP33002854. Thanks!

Hello Bobby. Based on the model and serial numbers, WP33002808 is the correct timer. Hope this helps.

Hello Art. Based on the model and the serial number you provided, WP33002808 is the correct timer and you will need to replace the wiring harness WP33002810 as well to repair the timer. The is per the manufacture. Hope this helps.

Hello Derek. Based on the serial number you provided, WP33002854 is the correct timer. Hope this helps.

Hello Myron! The timer for the given model is part number WP33002854. The harness is part number 33002756. Thanks!

Hello Donna! The timer used on your Maytag model and series is part numebr WP33002808. Per the manufacture, on this model you will also need to purchase a new wire harness WP33002810. Here are the instructions from the manufacture on how to remove the timer, thanks! Timer Removal: 1. Disconnect power to the machine. 2. Carefully life the timer knob and dial off the timer shaft by pulling the knob away from the face of the control console. 3. Remove the two timer mounting screws (now exposed on the control console) when the timer dial skirt is removed. 4. Disengage the console assembly from the top cover and roll forward. Console removal: 1. Disconnect power to the unit. 2. Remove the screws securing the console to the rear cover plate. 3. Lay a drop cloth across the top cover of the washer. 4. Grasp the top of the console and gently rock the top of the console forward away from the rear console back. Note the hooked tabs on bottom of the console, which engage in slots in the top cover. 5. For reinstallation reverse the aforementioned steps.

Hello Francisco! We will need your appliance serial number to determine the correct part number needed for your model. There has been a series change within the product that effects the timer on your appliance. However, here are some instructions located from the manufacture regarding the installation, hope they help! TIMER REMOVAL: 1. Disconnect power to the machine. 2. Carefully lift the timer knob and dial off the timer shaft by pulling the knob away from the face of the control console. 3. Remove the two timer mounting screws (no exposed on the control console) when the timer dial skirt is removed. 4. Disengage the console assembly from the top cover and roll forward. TO REMOVE THE CONSOLE ASSEMBLY: 1. Disconnect power to the machine. 2. Remove the three screws securing the console rear cover plate across the rear top edge of the console. 3. Lay a dropcloth across the top cover of the dryer. 4. Grasp the top of the console and gently rock the top of the console forward. 5. Roll the top of the console forward. 6. Carefully lift and roll the console forward onto the top cover. You now have access to the console components and wiring. 7. TO REINSTALL: Roll the console back into an upright postion, engaging the locking feet into the slots in the top cover. Replace the screws to attach console back to console rear panel.

Hello! The timer used on your Maytag model MDG8400AWQ serial number 17037073CC is part number WP33002808. Thanks!

Hello Jim! The timer used for your model MDE8400AYW and serial 10467205AT is part number WP33002854. Thanks!

Hello Bill! Per the manufacturer, when replacing the timer WP33002808 the harness WP33002810 will also need to be replaced. Unfortunately, they do not give the reasons why. Thanks!