Customer Questions and Answers for Electronic Control Board by Whirlpool

Leroy, To access the user interface/control, you have to remove the top and the console. Unplug washer or disconnect power. Turn off the water supply to the washer. Remove the three T-20 hex-head Torx screws from the top cover of the washer. Pull back on the cover and release the tabs in the console from the slots in the cover, then lift the cover off the unit. To remove the console: a) Pull out and disconnect cable connector from the central control unit. b) Remove the cable wires from the two central control unit clips. c) Pull the detergent dispenser drawer out as far as it will go, then press down on the release tab, and remove the drawer from the unit. d) Remove the one screw at the recessed hole.
e) Lift the top edge of the console and unhook it from the holder clips. f) Press the locking tab on the right rear side of the console inward, and remove the console. To remove the touchpad/LED assembly: a) Pull the selector knob off the switch shaft. b) Press the seven console locking tabs, and unsnap the touchpad/LED assembly, then lift the assembly from the console and remove it.

Hello Ramon. We are working daily at adding new videos to the website, but we do not have one for this repair at this time. Sorry.