Frigidaire Range FEF352BADA Won't start or doesn't start

This OEM replacement Universal Element Receptacle kit is designed to fit most popular range brands such as Maytag, Magic Chef, Jenn Air, Whirlpool, Roper, Kenmore, Frigidaire, Admiral, Crosley, Estate, and Amana. This kit comes complete with everything you need for a hassle-free installation.

Included in the Kit:

• Two different mounting brackets
• A plastic terminal block
• Wires
• Hi-temp wire connectors
• heat insulators

In case your oven or range is displaying any of the following signs: non-heating burners, malfunctioning heating elements, burning odor, or a buzzing sound, this kit could be the answer to the problem. To replace the kit, you would require specific tools such as wire strippers, a heat gun or hair dryer, and a #1 square-head screwdriver. 

The Large Surface Element Switch is an OEM replacement part for Frigidaire ranges and cooktops. It is a component that controls the power and temperature settings for one of the larger surface heating elements on the appliance.

Symptoms of a faulty Large Surface Element Switch include:

• Difficulty in adjusting or maintaining consistent heat settings
• The surface element not heating up or cycling on and off unexpectedly
• Flickering or erratic behavior of the surface element
• Burning smell or visible signs of overheating

Causes of a bad large surface element switch can include normal wear and tear, exposure to excessive heat or moisture, or electrical malfunctions.

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore range and cooktop models.

This factory replacement oven probe kit lets your range or wall oven sense temperature during probe-cook cycles. It restores reliable probe detection and accurate temperature feedback to help your control end cooking at the right time.

• Senses temperature and relays readings to the electronic control during probe-assisted cooking
• Supports probe-cook features that stop or hold when the target temperature is reached
• Common symptoms: "PROBE" error or no detection, erratic/stuck readings, or visible damage/corrosion on the probe or receptacle
• Replaces heat-damaged or worn probe components to ensure consistent contact and accurate feedback

• Disconnect power to the appliance before servicing
• Access may require removing the oven from the cabinet; route wiring along the factory path and away from hot surfaces
• Handle connectors and sensor tip carefully; do not kink the cable
• After installation, run a brief probe test per the user/service manual to confirm proper operation