General Electric Dishwasher EDW2020F01BB Not cleaning dishes properly

Replacement roller and axle kit for dishwasher lower racks. Includes 8 wheels and 8 axles. Replace when rollers are broken, cracked, or missing.

Fix a dishwasher that won't drain completely with this piston and nut valve assembly. Simple DIY repair when water remains in tub after cycles.

Replacement lower spray arm assembly for dishwashers. Installs at the bottom of the tub. Needed when the spray arm is cracked, broken, or tabs damaged.

Replaces broken or cracked 3rd level spray arm assembly that mounts at the top of the tub. Includes mounting tabs and collar for secure installation.

Replace broken or missing lower dishrack rollers and axles. Attaches to the bottom rack for smooth gliding when loading dishes. Sold as one roller kit.

Secures the end of the dishwasher rack slide rail. Replace if cracked, broken, or missing to prevent racks from sliding off track or misaligning.

Replacement fill cap for dishwasher rinse aid dispenser. Covers the fill opening to contain rinse aid properly. Replace if cracked, missing, or worn.

Replacement roller and stud assembly for dishwasher racks. Installs on upper or lower rack to restore smooth gliding. Needed when rollers crack or studs break.

Dishwasher not filling with water? A faulty water inlet valve is often the cause. This valve controls water flow into your dishwasher. 20-30 minute fix.

The Filter & Gasket Assembly is an OEM part for GE dishwashers. This part traps food particles and debris during the wash cycle, preventing them from redepositing on dishes or clogging the drain system. 

Causes of a bad Filter & Gasket Assembly can include wear and tear from regular use, accumulation of hard water minerals or detergents affecting the gasket's seal, and damage to the filter mesh that allows larger particles to pass through or clog the assembly.

Symptoms of a bad Filter & Gasket Assembly include:

• Poor cleaning performance, with food particles left on dishes after a cycle
• Water leakage around the dishwasher's base, indicating a compromised gasket
• Unpleasant odors from trapped food particles that are not properly filtered out

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.

Dishwasher not draining or leaving water in the bottom? This pump and motor assembly circulates and drains water. 2-hour DIY repair with video guide.

This kit is used to repair a leaking pump on GE made dishwashers. For a complete pump/motor assembly get WD26X10013.

Prevents water leaks at the dishwasher door corners during wash cycles. Replace if you notice leaking along the bottom of the door. Clips onto tub rail.

Rubber baffle prevents leaks at dishwasher tub corner. Replace if worn, cracked, or causing water leakage during wash cycles. Snap-fit design.

Dishwasher detergent cup won't stay closed or won't open fully? This soap dispenser lever controls detergent release. DIY repair in 15 minutes.

Middle spray arm assembly that directs pressurized water to the dishwasher's mid-level rack for improved cleaning coverage. Replacing a damaged or clogged arm helps restore spray rotation and reduce poor cleaning on the middle rack. What it does:

• Delivers rotating spray to the middle rack to rinse and wash dishes and utensils.
• Restores proper spray coverage when the arm is cracked, broken, clogged, or not rotating.
• Helps reduce leftover food, spots, and uneven cleaning on items in the middle rack.
• Integrates with the dishwasher's spray system to distribute water evenly across the mid-level.

What's included: One middle spray arm assembly. Install notes:

• Always disconnect power to the dishwasher at the breaker before beginning any service.
• Remove the middle rack to access the spray arm; follow the OEM instructions for removal and replacement.
• Inspect spray holes and rotation after installation and run a short test cycle to confirm operation.