General Electric Dishwasher GDF520PGD0BB Leaking

This hose clamp kit secures the washer's hoses at the pump, tub, or valve connections, helping stop leaks and hose blow-offs. Replace worn or missing clamps to restore a tight, reliable seal during fill, wash, and drain.

• Secures drain, pump, and fill hoses to fittings to maintain a watertight seal
• Helps prevent drips, leaks, and hoses slipping off during vibration
• Replaces clamps that are rusted, stripped, deformed, or missing
• Common symptoms: water leaking at hose joints, loose hose connections, clamp won't tighten
• Useful when installing a new hose, pump, or valve

• Unplug the washer and turn off water supplies; have towels or a pan ready for residual water
• Release and remove old clamps; seat the hose fully over the fitting before installing new clamps
• Tighten evenly and do not overtighten to avoid hose or fitting damage
• Restore power and water, then run a short cycle to check for leaks at each connection

The Lower Door Gasket is an OEM part for GE dishwashers. It is placed at the bottom of the dishwasher door to create a water-tight seal during operation, preventing leaks and ensuring that water remains within the unit during the wash cycle. 

Symptoms of a bad Lower Door Gasket include:

• Water leaking from the bottom of the dishwasher door
• Signs of mold or mildew near the gasket area
• Frequent puddles or drips underneath the door after a wash cycle
• The gasket becoming hard, cracked, or visibly damaged

Causes of a bad Lower Door Gasket can include regular wear and tear, exposure to harsh detergents and high temperatures, or improper installation that leads to uneven sealing.

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

This drain hose elbow creates a secure 90-degree connection in the dishwasher's drain line, helping route the hose cleanly while maintaining good flow. It supports a tight, leak-resistant turn where space is limited, reducing kinks and misrouting.

• Provides a 90-degree turn for the dishwasher drain hose to aid proper routing and flow
• Helps reduce kinks or crushing at tight bends that can slow or stop draining
• Forms a secure connection point to help prevent leaks at the hose junction
• Common symptoms of a failed or damaged elbow include leaks under the sink, visible cracks, kinks, or slow/poor draining

• Disconnect power and water supply; place a towel or pan to catch residual water
• Ensure the hose is fully seated on the elbow and secured with appropriate clamps per your model
• Route the drain line with a high loop or air gap as required by local code
• Run a short cycle and check all connections for leaks