General Electric Range JBP65DM2BB Won't start or doesn't start

The Oven Temperature Sensor Assembly is an OEM replacement part for GE electric wall ovens. It is responsible for accurately reading the oven's internal temperature to provide precise temperature control and safe operation. Consistent and precise temperature readings are necessary for repeatable cooking results.  

Symptoms of a bad temperature sensor include:

• Inability to reach or maintain set cooking temperatures
• Fluctuating temperatures causing inconsistent results  
• Error codes or fault messages related to temperature regulation
• Potential safety concerns if temperatures run too high or low

Causes of a faulty sensor can be due to failures over extended usage, exposure to high heat cycles, or impedance changes due to dirt or mineral deposits. Precise temperature readings allow for confident cooking.

This OEM GE replacement sensor is also compatible with Hotpoint, RCA, and some Kenmore electric wall oven models. 

The Oven Bake Element is an OEM replacement part for GE ovens. It is a crucial component that generates the heat necessary for baking and roasting functions within the oven cavity.

Dimensions:

• 18" side to side 19.50" from the mounting bracket to the back
• 2-3/4" between terminal centers
• 3" from the terminal to the back plate (calrod bent at a 45-degree angle)
• Male Spade 1/4" terminals

Symptoms of a bad oven bake element include:

• Uneven heating or hot/cold spots within the oven
• Oven taking longer than usual to reach the desired temperature
•  Element glowing irregularly or not at all during the baking cycle

Causes of a bad bake element can range from simply burning out due to repeated use over time to physical damage caused by drips, spills, or impact.

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.