General Electric Range JBP90BF2BB Element will not heat

The Large Haliant Element is an OEM replacement part for GE ranges/cooktops. This haliant burner element is 8 inches in diameter. The element lies underneath the stovetop and will need to be replaced if it stops heating. 8-inch 2100 watt. Includes limiter

Causes of a bad halogen element can include cracked or damaged ceramic material, broken support coils, or malfunctioning heating coils.

Symptoms of a bad halogen element include:

• Element not heating up properly or unexpectedly shutting off
• Burned-out coils or melting/warping of the protective, reflective dish

This is a genuine OEM part that works for some models of GE, and Hotpoint models.

The Bake Element is an OEM part for GE ovens, designed to provide the heat necessary for baking. This element is located at the bottom of the oven cavity and heats up when electricity is applied, converting electrical energy into heat to cook food evenly. 

Over time, however, the bake element can wear out or become damaged.

Symptoms of a bad Bake Element include:

• Visible signs of wear or damage, such as blistering, cracks, or breaks in the element.
• A burnt out element that no longer glows red or heats up.
• Food not baking evenly or thoroughly.

This OEM GE part can also be used on Hotpoint, RCA, and Kenmore/Sears appliances. 

The Infinite Control Switch is an OEM replacement part for GE electric stoves. This component acts as the main selector switch for a Dual Coil Element stove to function in different modes and settings.

Symptoms of a bad infinite control switch include:

• Difficulty selecting or functioning in certain cooking modes or programs
• Stove burners or ovens not igniting or heating as selected  
• Controls flickering, blinking, or becoming unresponsive

Causes of a bad control switch can be normal wear from frequent use over time, loose connections from vibration, or potential spills that cause internal damage.

This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore electric stove models. 

The Oven Temperature Sensor Assembly is an OEM replacement part for GE electric wall ovens. It is responsible for accurately reading the oven's internal temperature to provide precise temperature control and safe operation. Consistent and precise temperature readings are necessary for repeatable cooking results.  

Symptoms of a bad temperature sensor include:

• Inability to reach or maintain set cooking temperatures
• Fluctuating temperatures causing inconsistent results  
• Error codes or fault messages related to temperature regulation
• Potential safety concerns if temperatures run too high or low

Causes of a faulty sensor can be due to failures over extended usage, exposure to high heat cycles, or impedance changes due to dirt or mineral deposits. Precise temperature readings allow for confident cooking.

This OEM GE replacement sensor is also compatible with Hotpoint, RCA, and some Kenmore electric wall oven models. 

The Element Convx is an OEM part for GE ovens. This convection element is designed to provide consistent and even heat distribution within the oven, ensuring optimal cooking and baking results. It typically works in conjunction with the convection fan to circulate hot air evenly throughout the oven cavity.

Causes of a bad convection element can include regular wear and tear, electrical surges, or damage from physical impact. A malfunctioning element can lead to uneven cooking, longer preheating times, and overall reduced oven performance.

Symptoms of a bad convection element include:

• Uneven cooking or baking results
• The oven not reaching the set temperature
• Longer than usual preheating times
• The convection fan operating without generating heat

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.