General Electric Range PGS968BEM2BB Won't start or doesn't start

The Oven Igniter Assembly is an OEM part for GE ovens. This assembly is responsible for igniting the gas to provide heat for cooking. It ensures the oven reaches and maintains the set temperature by igniting the gas burner whenever the oven is in use.

You should replace the oven igniter assembly if it becomes faulty. Causes of a bad igniter include wear and tear over time, electrical failures, or damage from excessive heat exposure. A malfunctioning igniter can prevent the oven from heating properly, leading to uneven cooking or failure to reach the desired temperature.

Symptoms of a bad Oven Igniter Assembly include:

• The oven not heating up
• The igniter not glowing or sparking
• Uneven cooking or baking results
•  The smell of gas without ignition

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

The Oven Temperature Sensor Assembly is an OEM replacement part for GE electric wall ovens. It is responsible for accurately reading the oven's internal temperature to provide precise temperature control and safe operation. Consistent and precise temperature readings are necessary for repeatable cooking results.  

Symptoms of a bad temperature sensor include:

• Inability to reach or maintain set cooking temperatures
• Fluctuating temperatures causing inconsistent results  
• Error codes or fault messages related to temperature regulation
• Potential safety concerns if temperatures run too high or low

Causes of a faulty sensor can be due to failures over extended usage, exposure to high heat cycles, or impedance changes due to dirt or mineral deposits. Precise temperature readings allow for confident cooking.

This OEM GE replacement sensor is also compatible with Hotpoint, RCA, and some Kenmore electric wall oven models.