Kenmore Washer 110.21392011 (11021392011, 110 21392011) Will not agitate or doesn't agitate

The washer drive belt transfers motor power to the washer’s drive system so the basket spins and agitates. Replacing a stretched or broken belt helps stop squealing and slipping so cycles finish at proper spin speed.

What it does

• Links the drive motor to the washer’s drive/pulley system
• Restores spin and agitation when the belt is worn, glazed, or broken
• Can reduce squeal or burning-rubber smells from belt slip
• Helps prevent intermittent or no-spin conditions

What’s included
One drive belt.

Install notes

• Unplug power; turn off water
• Tip the washer back; remove the bottom shield/cover if present
• Route the belt over the motor and drive pulleys; rotate by hand to seat fully
• Inspect pulleys/drive parts for wear; run a spin or calibration test after install

This OEM Whirlpool belt is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore washer models.

This kit includes the splutch pulley and cam assembly used in the washer's drive system to engage the spin and agitate modes. The splutch mechanism sits beneath the outer tub and works with the drive motor to switch between washing and spinning cycles. Replace this kit if the washer fails to agitate, won't spin, or makes grinding or clicking noises during operation.

Fix a washer that won't spin, agitate, or shows F7-E1/F7-E7 errors with a new shift actuator. Controls cycle transitions. Easy DIY repair with video guide.