Kitchenaid Dishwasher KUDD03STBL0 Leaking

The Air Duct Bezel is an OEM part for Whirlpool dishwashers. This component is designed to direct airflow within the dishwasher, ensuring that dishes are properly dried after the washing cycle.

Causes of a bad air duct bezel can include regular wear and tear, buildup of detergent or food particles, or physical damage due to mishandling. A malfunctioning air duct bezel can lead to poor drying performance and potentially cause dishes to remain wet or have water spots after a cycle.

Symptoms of a bad Air Duct Bezel include:

• Dishes not drying properly
• Increased moisture or condensation inside the dishwasher
• Noticeable damage or cracks in the bezel
• Unusual sounds during the drying cycle

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

The Hose Clamp is an OEM part for Whirlpool appliances. It secures hoses in place, ensuring a tight connection and preventing leaks in various systems such as washing machines, dishwashers, and refrigerators. This clamp is crucial for maintaining the integrity of the water or air lines it secures.

Causes of a bad hose clamp include wear and tear over time, exposure to water and detergents, or mechanical stress from repeated tightening and loosening.

Symptoms of a bad hose clamp include:

• Leaks at the hose connection points
• Hoses slipping off the connections
• Visible rust or damage on the clamp
• Reduced appliance efficiency due to leaks

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This hose clamp secures a hose connection to prevent leaks and keep your appliance running smoothly. It provides a tight, reliable hold on the hose fitting so water or air stays contained during operation.

• Tightens around a hose and fitting to maintain a secure seal
• Helps stop drips, seepage, or loose connections
• Common fix when you see moisture around a hose joint
• Useful if a clamp is rusted, stretched, or no longer holding tension

• Unplug power and shut off water (if applicable) before servicing
• Note clamp position/orientation before removal
• Use appropriate screwdriver or nut driver to tighten evenly
• Do not overtighten—ensure a snug, leak-free seal without damaging the hose