Maytag Dishwasher MDB7601AWS Won't start or doesn't start

The Door Latch Assembly is an OEM replacement part for Whirlpool dishwashers. It is responsible for securely latching and locking the dishwasher door during operation, preventing leaks and ensuring a proper seal.

Symptoms of needing to replace the door latch assembly include:

• Difficulty in properly closing or latching the dishwasher door
• Leaks or water seeping out from around the door area
• Visible signs of wear, damage, or cracks on the latch mechanism
• The door not staying securely closed during operation

Causes of a faulty dishwasher door latch assembly can include normal wear and tear over time, physical damage due to impact or mishandling, or issues with the latch mechanism itself.

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore dishwasher models.

This electronic control board kit is the appliance's central controller, coordinating inputs and powering key components. Replacing a failed board restores proper operation, responsive controls, and reliable cycle management. What it does:

• Manages timing and power to motors, valves, heaters, fans, and other loads
• Interprets sensor and user-interface signals to start, run, and end cycles correctly
• Common failure signs: dead or unresponsive controls, cycles that won't start/finish, repeated error codes, or intermittent operation
• Helps address issues caused by power surges or board damage

• 1 electronic control board (module)

• Disconnect electrical power to the appliance; turn off gas/water if applicable
• Use ESD protection and handle the board by its edges
• Photograph wiring; transfer connectors one at a time and match any jumpers/DIP-switch settings from the original board
• Restore power and perform any model-specific tests or programming per OEM instructions

The Door Latch is an OEM part for Whirlpool dishwashers. It secures the dishwasher door during operation, ensuring it stays closed and maintains a tight seal to prevent water leaks. This latch also activates the safety switch, allowing the dishwasher to start its cycle only when the door is properly latched.

You should replace this door latch if it becomes worn out, damaged, or fails to secure the door properly. Common causes of a bad latch include repeated use, physical damage from forceful closing, or misalignment of the latch components.

Symptoms of a bad door latch include:

• Dishwasher door not staying closed
• Dishwasher not starting or stopping mid-cycle
• Water leaking from the door during operation
• Difficulty in latching or unlatching the door

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

Note: This is the latch only and does not include the handle. For the latch with handle, order part# WPW10130695 which includes a black handle. The factory only offers the latch handle assembly in black. No other colors are available.