Maytag Washer LAT2300AAE Timer will not advance

This washer timer is the mechanical cycle controller that sequences power to the motor, pump, and water valves. Replacing a worn timer restores proper cycle advancement so the washer starts, progresses, and stops at the correct times.

• Controls the length and order of wash, rinse, and spin cycles
• Directs power to the drive motor, drain pump, and inlet valves as the cam advances
• Advances the cycle automatically; interfaces with the timer knob for manual selection
• Failure symptoms include cycles not advancing, stopping mid-cycle, skipping steps, or no start

• Disconnect power and turn off water supply before servicing
• Access the control panel; remove the knob/dial and mounting screws to release the timer
• Note wire positions or take a photo; transfer connectors one at a time to matching terminals
• Reinstall, secure the timer, and run a short test cycle to ensure proper advancement