Whirlpool Washer IP41002 Will not agitate or doesn't agitate

Washer won't spin or agitate? A broken motor coupling disconnects the motor from the transmission. DIY repair in 30-45 minutes with basic tools.

Washer won't start, agitate, or spin? A faulty lid switch is the likely cause. This safety switch is easy to replace in under 5 minutes with basic tools.

Washer won't spin or leaves clothes soaking wet? A worn clutch assembly prevents the tub from spinning properly. Moderate DIY repair with video guide.

Fix a washer that won't spin or agitate with a new transmission. Common symptoms include loud clunking noises or clothes staying wet after cycles.

The Clutch Band and Lining Kit is an OEM part for Whirlpool washing machines. It contains the clutch band and clutch lining components essential for proper transmission of power from the washer motor to its drum during the spin cycle. The clutch band and lining allow for a controlled amount of slippage to safely extract water from clothes without damage. 

Symptoms of a bad clutch band and lining include: 

• Excessive noise or vibration during spin
• Slow or ineffective spinning 
• The drum failing to spin or “locking up”
• Premature wear of other transmission parts

Over time and with heavy use, these components can wear down. If slipping or damage is detected, it’s important to replace the kit to avoid potential transmission repairs.

This OEM Whirlpool part can also be used on Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore/Sears brand appliances.

If your washer agitator spins freely or clothes tangle around it, the splines may be stripped. This center post assembly restores wash action. 15-min DIY.

Rubber grommet for motor mount stud.