Matthew M Terryville , CT June 12, 2015 Upper and lower nozzles would come off during washer cycle Replaced nozzles. Read More... 5 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes
Steve L Evans , CO October 22, 2016 Bottom spinner kept coming off When I disassembled the bottom part I learned that the rubber gasket wouldn't go back in. It somehow became stretched and couldn't be reinstalled. I read that this is very common. I purchased the bottom rubber gasket, bottom holder and spinner. Simple fix...done in about 10 minutes. The products worked perfectly and delivery was FAST! Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Brian K Brookfield , WI November 18, 2014 Lower spray bar kept popping out of the holder Replaced the holder and the spray bar, May have been able to just replace the holder but wanted both parts to be new because both where worn. Lots of screws to take out so a power screw driver is good to have. Read More... 3 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Edward K Sterling Heights , MI February 23, 2020 Appliance: Samsung Dishwasher DMT300RFS/XAC-00 Lower spray arm kept falling off leaving dirty dishes Installed a new nozzle holder and lower nozzle. The only issue I ran into was the pump cover rubber gasket was stretched. I put it in the freezer for awhile and it shrunk just enough so that I could work it into the channel. Dishwasher cleans perfectly now. Fast delivery on the new parts. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers
Ronald M Orlando , FL June 05, 2015 Appliance: Model SAMSUNG ??? Dishwasher door became heavy to close Ordered replacement part (short piece of rope with a nylon fitting) that attached to the spring to apply tension on the opened door. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Adjustable Wrench, Pliers, Screwdrivers