John W Stewartsville , NJ April 27, 2020 The control assembly broke where the dispenser is located. The dispenser housings hose was leaking, which was damaged from the loose dispenser housing I replaced the control panel and the dispenser housing hose. The unit is no longer leaking. Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Pliers, Screwdrivers
Jerry T Nixa , MO June 14, 2019 Front load washing machine soap dispenser hose was cracked and leaking Removed top from washing machine (6 screws). Removed two clamps by hand and removed cracked hose. Ordered part from Appliance Parts Pros, perfect replacement. Reassembled washer, no leaks working great..... Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Aaron R Warrenton , MO February 04, 2023 Water leaking Remove the top of washer by removing 2 Phillips head screws in the rear of the top panel. Then slide the to panel back and lift off the machine. The hose is in so the rear of the soap dispenser ( big white square box in the front of the machine that your soap drawer slides into) all the water that enters the washing machine enters through this tube at the rear of the dispenser. My hose was torn between the baffles at the bottom of the hose allowing water to leak every time it filled. Remove the clamp by switching either by hand or with pliers if needed at the rear of the dispenser and do the same wear it enters the drum. Pull the hose off and install the clamps on the new hose allowing room to push the new hose onto each corresponding location. Reinstall the clamps in the proper location. Now run the machine to test for leaks. If no leaks, reinstall the top by sliding it back on and reinstall the 2 screws at the rear. Super easy fix and definitely the first place to check! I didn't start here and went through every hose on the bottom of the machine first which was much more difficult. This was the culprit all along. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Pliers, Screwdrivers