Matt R North Yarmouth , ME August 22, 2015 Appliance: Samsung Dishwasher DW80F800UWS/AA-0000 Ie error code first during wash then immediately after powering on The model number on the dishwasher did not have a -0000 or -0001 on the end of the model number so I bought the part for both models. I assume if yours doesn't have it, then it is the -0000 model like mine, which of course means the more expensive part. You can always buy both and return the one you don't need. Replacing the temperature sensor was fairly simple - disconnect power and water, pull the right-side panel off, move the noise filter out of the way, turn the sensor a quarter turn counter-clockwise and pull it out, then swap the o-ring to the new sensor, and then reverse the steps. Before pulling out the old sensor, have some rags or paper towels on hand to absorb the water that will leak from the housing when there is no sensor to stop it. Dishwasher now runs full cycles without issue. Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Pliers, Screwdrivers
Stephen L Houston , TX September 14, 2020 Appliance: Model DW80F600UTS/AA. 01 Auto and normal lights flashing indicating high temp error. Replaced the thermistor. Bad 1 reading about 1400 ohms. New one read 45k ohms Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
John A Madison , WI November 11, 2019 Appliance: Samsung Dishwasher DW7933LRAWW/AA-01 Smart auto + normal lights blinking Replaced thermistor Read More... Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Pliers, Screwdrivers
Ryan H Rosharon , TX April 21, 2017 The thermistor had gone out I researched the part that I needed. I found it on AppliancePartsPros and had it shipped. Shipping was amazingly fast, customer service was very helpful. I was able to put the dishwasher and its back, access the bottom panel and easily take out the old one and replace it with the new one in about 15mins. It works like a charm. Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers
Ernie W Kissimmee , FL April 25, 2017 Error code for high temp. Replaced thermistor Please note to catch water When removing thermistor Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Adjustable Wrench, Wrench Set