11047789 Parts

This is a leveling foot for a washing machine. A leveling foot is located at the bottom of the washing machine and can be adjusted so that the washing machine sits level on the floor, even if the floor itself is not level. There is one leveling foot included in this pack. A new leveling foot may be needed if the original is broken or stripped. If it won't hold a position, then the leveling foot will need to be replaced. These are very simple to replace, with the exception of needing to reach underneath the unit. These screw into the bottom of the washing machine. Never perform care and maintenance on an appliance that is powered on.This is a genuine Whirlpool part and is sourced directly from the manufacturer. It is sold individually. This specific leveling foot is compatible with washing machines manufactured by Whirlpool, KitchenAid, and Maytag.

The door back support frame provides structural support for the washer door and houses the door seal and locking mechanism. Located on the rear side of the front-loading washer door, replace it when the door won't close properly, the seal is damaged, or there are cracks in the frame.

This is a hose connector that attaches to the outlet or drain hose on the washer, ensuring a secure, leak-free connection for water flowing out of the machine. Replace this connector if you notice water leaking at the hose junction, if the connector is cracked or corroded, or if the hose keeps slipping off during the drain cycle.

This is the lower cover panel for the detergent dispenser drawer on a front-load washing machine. It snaps onto the bottom of the dispenser drawer to enclose the compartment and direct water flow properly during the wash cycle. Replace this cover if it is cracked, missing, or warped, which can cause detergent to dispense incorrectly or water to leak from the dispenser area.

Replaces the large stationary outer tub that holds water and supports the inner basket. Order when tub is cracked, leaking, or structurally damaged.

This is a single replacement screw used to secure appliance panels and components. It restores proper fastening to help eliminate looseness and rattling and keep parts aligned for safe operation. What it does:

• Secures trim, panels or internal components to maintain proper alignment
• Prevents rattling or vibration caused by loose fasteners
• Replaces missing or stripped screws for safe, reliable fit
• Works wherever the OEM screw specification and fit match the original

• One screw as shown

• Disconnect power and/or gas before accessing internal components
• Use the proper driver size and avoid over-tightening to prevent thread damage
• Verify correct screw placement against the appliance's service diagram

Fixes F02 drain error codes and slow draining. This small ball creates a seal in the tub-to-pump hose to control water flow. Simple DIY replacement.

Includes water temperature sensor.

Replacement outer tub for front-load washers. Houses the spin basket and seals water inside during wash cycles. Replace if cracked, damaged, or leaking.

Replace this washer O-ring seal to stop leaks and restore watertight connections. Install when you notice drips or water damage at joints. Verify fit.

Secures the drain hose to the washer cabinet or pump. Replace this retainer clip if it's broken, cracked, or missing to keep the hose properly attached.

Replacement water inlet hose for washers. Connects to water supply and directs incoming water into the machine. Replace if cracked, leaking, or damaged.

Flexible water connection hose for washers. Replace this hose if cracked, split, kinked, or leaking. Connects water supply between components.