Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Wire harness for dryers and laundry centers. Connects electrical components inside the cabinet. Replace if wires are frayed, damaged, or burnt.
Dryer drum seal prevents heat loss and improves efficiency. Replace if you notice excessive lint, reduced drying performance, or visible wear. Confirm fit with your model number.
Molded elbow connector that redirects dryer exhaust to your home vent duct. Replace if cracked, loose, or leaking to restore a secure connection.
Adjustable periscope vent for dryers with limited clearance. Installs between dryer exhaust and wall port. Replace if cracked, damaged, or missing.
Use the slide adjusting dryer vent with the 2" clearance instead of 4" dryer vent hose. This cave us the clearance needed to install the dryer. Read more
Touch-up paint bottle restores chipped or scratched dryer surfaces. Covers small nicks and scratches to improve appearance and protect against rust.
Replaces a damaged, bent, or missing dryer vent duct. Directs exhaust air from your dryer to the home's exterior venting system for safe operation.
Fix washer control issues with this switch mounting screw. Secures cycle selector switch in console for reliable function. Simple DIY fix in minutes.
I had the problem couple years ago I bypassed unbalance switch it worked fine for a couple years and had the same problem again so ruled out unbalanced switch. Door lock light on and checked made sure wax motor pushed out all the way too the second switch for spin check OK, so took a chance on displacement switch x2. My family loves to over load it and also replaced by passed unbalance switch and boom every thing went back to normal. Its also good to clean every thing when apart. Read more
Adjustable periscope vent for tight dryer installations. Extends 18-29 inches to connect 4-inch dryer vent to wall exhaust in close quarters.
8-foot flexible dryer vent hose connects your dryer to the wall exhaust duct. Replace if cracked, torn, disconnected, or showing wear that could cause lint buildup.
Replace your dryer's fill hose if it's cracked, leaking, or worn. This hose connects the water supply to your dryer for steam cycles and proper operation.
If your dryer's steam sprayer won't stop or steam isn't working, the steam valve likely failed. Located in back, tested with 120VAC during cycles.
Square blower housing that surrounds and supports the centrifugal fan assembly in the rear upper compartment. Replace if cracked, broken, or damaged.
Fix a dryer that won't fill or leaks water with a new water inlet valve. Controls water flow to steam dryers. Moderate DIY repair in 30-45 minutes.
Mounting screw for dryers, electric wall ovens, washers, and laundry centers. Secures panels, brackets, or components. Replace if missing or stripped.
Exterior vent hood for dryer exhaust systems. Replaces cracked, broken, or missing vent covers. Installs at outdoor vent exit point.
Secures flexible hoses to fittings to prevent leaks and detachment. Replace if rusted, loose, or damaged. Verify fit with your dryer model number.