11080Series Parts

Mounting nut that secures the idler bracket to the base of your washer. Replace if stripped, missing, or damaged to properly anchor the bracket assembly.

Lower elbow duct hose for laundry centers. Directs airflow between dryer components. Replace if cracked, disconnected, or causing poor ventilation.

Size: 8-18 x 3/4 inch.

Truss head machine screw for lawn mowers, snowblowers, and tillers. Replaces lost, stripped, or damaged screws in engine, deck, or housing assembly.

Size: 6 foot. This washer fill hose can be used for the hot or cold.

Bell washer for lawn mowers and outdoor power equipment. Replaces cracked, worn, or missing washers. Installs between components for proper spacing.

Replace your dryer's worn, cracked, or missing control knob. Mounts on the control shaft to select cycle settings and temperatures. Restores grip and clarity.

Secures the control console to the cabinet, preventing rattles and loose movement. Replace when the panel sags or won't stay in place. Confirm fit.

This cable tie secures wiring and the power cord to the appliance chassis to help prevent chafing, pinching, or loose connections. Simple, low-cost part that restores proper wire routing and strain relief. What it does

• Holds wiring and harnesses in place to prevent rubbing against sharp edges
• Helps reduce risk of intermittent power or connector strain caused by loose wires
• Keeps harnesses routed for correct clearance and component access
• Useful during repairs to restore original wire routing and strain relief

• One cable tie (wire harness retainer)

• Safety first: disconnect the appliance from power before inspecting or replacing wiring components
• Remove the damaged or existing retainer and route harnesses to match original OEM routing before installing the new tie
• Trim excess tie tail; do not overtighten—secure, but avoid crushing wires
• Replace any tie that's melted, cracked, or otherwise damaged rather than reusing it

This is a door panel that forms the main structural face of the dryer door. It works with the inner door liner and other door components to seal the drum during drying cycles. Replace this panel if it is cracked, warped, dented, or if the door no longer closes or seals properly.