20160Uc/23 Parts

Replacement screw that secures the pawl friction plate in lawn and garden engines. Replaces lost, stripped, or damaged flange bolts on the recoil assembly.

This replacement friction spring is a genuine OEM part meant for any number of small appliance engines run using a starter rope. This spring absorbs large amounts of kinetic energy that could damage the starter rope pulley system. It helps keep the pulley from being overstretched, which would create enough pressure to break the entire system. This spring sits at the center of the pulley system and creates resistance as the user yanks the starter rope. Friction springs can become worn out after repeated use, especially if a user tends to yank the starter rope quite forcefully. The most obvious sign of a worn of friction spring is if the pulley system lacks any resistance. As the user pulls the cord, they should feel a little pull back, but if the friction spring is worn, there will be much less resistance. Replacing this part is straightforward and will only require a screwdriver. Simply open the pulley system, carefully remove the old spring, and install the new one. This part is compatible with a wide number of appliances from Toro, Vanguard, Briggs & Stratton, and Lawnboy. It comes sourced from the original manufacturer and ships individually.

Engine won't shut off when you turn the key? Replace your lawn mower's stop switch to restore safe engine control. Simple safety repair.

E-shaped retainer clip for lawn mowers, snowblowers, and pressure washers. Replace when cracked, broken, or missing to secure engine components.

Crankcase gasket seals cylinder assembly to crankcase. Replace if oil leaks or engine loses compression. Verify fit with your model number.

Engine won't start when you pull the cord? This rewind starter assembly lets you hand-crank your lawn mower engine. Moderate DIY repair for most users.

This genuine OEM part is a rocker switch for lawnmower engines. A rocker switch is the component that allows the user to power the engine. If the rocker switch is no longer functioning and not turning the engine on and off as intended, it might need to be replaced. While replacing a rocker switch may seem like a difficult task, it is actually a simple fix.To replace the rocker switch, pry it off using a flathead screwdriver. Once removed from the mower, unplug the wire harness attached to it. Once unplugged, replace with the new switch. Snap the switch back into its original position and test if it has been installed correctly. If the mower turns on and the engine is able to start, then the installation was a success.This replacement part is sold individually and is compatible with Briggs and Stratton lawnmowers.

Replacement screw for lawn and garden engines. Used to secure components during assembly. Replace if original is lost, stripped, or damaged.

Tap screw for lawn mowers and tractors. Secures panels, guards, and components. Replace if stripped, rusted, or missing to restore proper assembly.

Replacement bolt for lawn mowers and outdoor power equipment. Secures components and ensures stable assembly. Order a new bolt if yours is missing or damaged.

Spacer component for lawn mowers and tillers. Reduces friction between parts while maintaining proper spacing. Replace if worn, damaged, or missing.

Mower won't start or runs poorly? Cracked or leaking fuel lines prevent proper fuel delivery. Simple 15-minute DIY repair restores engine performance.

Can't start your lawn mower engine? A worn or broken ignition switch key prevents operation. Direct replacement restores on/off control in minutes.

Replacement blower housing for lawn and garden engines. Covers and protects internal blower components. Replace if cracked, broken, or damaged.

This replacement part is a casing clamp. It is a genuine replacement part made by MTD. This part is typically used to secure the governor control plate to the tank assembly.A new casing clamp might be needed if the current one is damaged or missing. Be sure the machine is stationary and the engine is completely powered down before beginning this repair. This part is made of durable metal so that it works properly with the machine at hand. Refer to the owner's guide for more information on this part. This air cleaner is a genuine OEM replacement part. This part is sold individually and is sourced directly from the manufacturer to ensure a proper fit.