26622690 Parts

Protective shield for washer dryer combo tubs. Replaces cracked, broken, or missing shields. Installs around the tub to prevent damage and leaks.

Secures hoses in your laundry center. Replace if leaking, loose connections, or visible corrosion occur. Verify fit with your model number before ordering.

This motor bracket secures the appliance motor to the housing so the motor stays aligned and stable during operation, helping maintain proper drive function and reduce vibration. What it does

• Provides a secure mounting point for the motor to keep correct alignment with belts or shafts
• Reduces motor movement and vibration that can cause noise or wear
• Helps maintain proper drive geometry to support consistent operation
• Commonly replaced when the original bracket is cracked, bent, or broken

• One motor bracket

• Disconnect power before starting any repair to avoid electrical shock
• Inspect mounting hardware and surrounding components; replace any damaged fasteners
• Tighten fasteners to the manufacturer's specification and verify motor alignment before testing

This SCR 8-18 AB 1/2 is a replacement silicon controlled rectifier that restores proper power control to the appliance's control circuitry, helping the unit switch and regulate current reliably. What it does:

• Controls current flow in the appliance's power/control circuit for timed or regulated output
• Replaces a failed or intermittent SCR to stop erratic cycling, no-power, or control malfunctions
• Commonly used where electronic switching or phase control is required
• Helps restore stable operation when heating or motor circuits fail to receive proper control signals

• One SCR 8-18 AB 1/2 replacement component

• Disconnect power to the appliance before inspecting or replacing electrical components
• Observe ESD precautions and handle the SCR by its body; avoid touching leads
• Verify wiring and mounting orientation match the original part before final assembly

A small replacement hose clip that secures flexible appliance hoses to fittings to help prevent leaks and disconnections. Fits commonly used appliance hose connections to restore a secure seal and reliable water flow. What it does:

• Secures a water or drain hose to a barb or fitting to prevent the hose from coming loose
• Helps stop leaks and drips caused by loose or slipping hoses
• Prevents hose movement and rubbing that can lead to wear or abrasion
• Useful when a hose slips off during operation or after maintenance

• Disconnect power and shut off the water supply before servicing the appliance
• Use appropriate hand tools (needle-nose pliers or hose clamp pliers) to open and seat the clip
• Position the clip over the fitting and tighten until the hose is snug and secure; avoid over-tightening
• Replace only with the correct OEM-style clip for a proper fit

Washer not filling properly or overfilling? This pressure switch harness connects the water level sensor to control board. Moderate 30-minute repair.

Secures the washer agitator to the drive shaft. Replace if lost, stripped, or rusted to eliminate wobble and restore proper agitation during wash cycles.

Plastic cup that holds the suspension rod at the tub connection point. Replace if cracked, worn, or broken to restore proper tub support and alignment.

Secures the drive pulley to the motor shaft in your washer. Replace if worn, loose, or missing to prevent pulley wobble and maintain proper belt alignment.

Fix non-responsive controls or dead unit issues with this main wiring harness. Restores electrical connections between control board and components.

Secures your dryer motor to the cabinet to reduce vibration and noise. Replace if motor shifts or rattles during operation. Confirm fit with your model.

Hex screw for lawn mowers and outdoor power equipment. Secures components and panels. Replace if stripped, rusted, or missing for proper assembly.