3070618 Parts

Body-side spacer for gas range door or lid hardware. Installs on cabinet side to set correct stand-off and alignment. Replace if cracked or missing.

Specs: 8 - 18 x 0.500

Support plate that mounts to the bottom of your range oven cavity. Replace if the original plate is cracked, warped, or damaged from heat exposure.

If your gas range burners won't ignite or clicking continues after lighting, the spark module may have failed. A moderately difficult repair.

Fix a range burner that won't heat or stays on constantly. This infinite switch controls surface element temperature. Moderate DIY repair in 30-45 minutes.

Rubber bumper that cushions the range door or drawer when closing. Replace if cracked, worn, or missing to prevent rattling and protect surfaces.

Secures the oven bottom panel in place. Replace if screw is stripped, missing, or no longer holds the panel securely. Sold individually.

Replacement housing cover for your range. Installs on the exterior or internal housing assembly. Order a new cover if yours is cracked, broken, or missing.

Mounting bracket that secures the gas pressure regulator to your range frame. Replace if bent, broken, or missing to properly support the regulator assembly.

This thermal cutoff is a temperature-sensing safety thermostat that helps prevent overheating by interrupting power when excessive heat is detected. Use it to restore proper safety protection in affected appliance heater or control circuits. What it does:

• Monitors temperature and opens the circuit if heat rises above the designed threshold
• Helps prevent overheating-related damage or fire risk in heating systems
• Stops power to heating elements when a fault causes unsafe temperatures
• Commonly used with ovens, dryers, and other heater-equipped appliances as a fail-safe

• One thermal cutoff

• Power must be disconnected before inspection or replacement to avoid shock or injury
• Handle the part carefully and observe wire connection orientation; replace with same type only
• If other components show heat damage, inspect the whole heating circuit and controls

This replacement door gasket creates a tight seal around the refrigerator or freezer door to help maintain consistent temperatures and reduce energy loss. Designed to match the OEM shape and restore proper sealing. What it does:

• Seals the door edge to help keep cold air in and warm air out
• Helps prevent frost buildup and reduces compressor run time when sealing properly
• Can stop drafts and eliminate wet or warm spots on door edges
• Restores the door's original fit when worn, torn, or deformed

• One door gasket

• Designed for a direct replacement; inspect mounting channel and retainer before installing
• Warm the gasket slightly for easier fitting if needed; avoid overheating
• Clean the door frame and remove old adhesive or debris for a proper seal

Replacement handle for your range utility drawer. Installs on the front of the warming or storage drawer. Order a new handle if yours is cracked or broken.

Pressure regulator for gas ranges. Controls gas flow from supply line to burners and oven. Replace if worn, damaged, or causing pressure issues.