596-Kenmore Parts

This overload is a thermal protection device that mounts on the motor/compressor and opens the circuit when excessive heat or current is detected. Replacing a weak or failed overload helps restore safe startup and protects the windings from damage. What it does:

• Monitors motor/compressor temperature and current draw
• Interrupts power on overheat/overload to prevent damage
• Aids troubleshooting of start/run issues when paired with the start device
• Common symptoms: hums then clicks off, won't start, intermittent shutdown, frequent tripping

• 1 thermal overload protector

• Disconnect power before servicing; allow components to cool
• Access the terminal area on the motor/compressor; remove any cover
• Note/photograph wire positions; transfer wires and fully seat the new overload on the correct terminal
• Inspect the start relay, capacitor, and terminals for heat damage; replace any compromised parts

Compression nut for 5/16" plastic water line.

This thermistor is the refrigerator temperature sensor that monitors internal air temperature and helps the control board regulate cooling for safe food storage. It replaces a failed sensor to restore accurate temperature readings and normal cycling. What it does:

• Senses refrigerator/freezer air temperature so the control board can adjust compressor and fan operation
• Can cause improper cooling or erratic cycling when faulty (too warm, too cold, or constant running)
• Helps the appliance respond correctly to user temperature settings and defrost cycles
• Works as part of the temperature control system; not a standalone control module

• Disconnect power to the appliance before beginning any service to avoid shock or injury.
• Handle the sensor tip and wiring gently; avoid kinking or damaging the harness.
• Verify correct connector alignment and secure fit to the harness; test operation after installation.