We use cookies and similar tools for site analytics and advertising. By using our site, you agree to this. See our Privacy Policy for details. Do Not Sell or Share My Personal Information
Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Hex head screw for lawn tractors and outdoor power equipment. Replaces lost, stripped, or damaged hardware. 5/16-18 thread size for secure assembly.
Hex jam nut fastener for lawn mowers and tractors. Secures components and hardware throughout the machine. Replace if stripped, rusted, or missing.
Bell washer for lawn mowers and tractors. Installs to secure components and prevent loosening. Replace if cracked, worn, or missing for proper assembly.
Shield spacer for lawn tractors and riding mowers. Provides proper spacing and alignment for protective shields. Replace if missing, damaged, or worn.
This is a 2-pin normally closed microswitch used to detect the position of a door or component within the appliance. It sends a signal to the control board to enable or disable operation based on whether the door or latch is properly engaged. Replace this switch if the appliance fails to start, does not recognize that the door is closed, or behaves erratically.
Counterbalances your dishwasher door for smooth opening and closing. Replace if cracked, broken, or fatigued to prevent door from dropping or slamming.
So I noticed a few months ago that the dishwasher door felt a lot heavier than it used to. Then just recently I opened it and heard something snap and the door came crashing down onto my foot! Ouch!! The door was still able to close but opening it required it being fully lowered by hand. I had no idea how heavy the dishwasher door was! So I got down onto the kitchen floor with a flashlight. I removed the metal panel at it’s base by lifting it up and pulling it out. Once I was able to get a... Read more
Usually ships within 4 - 14 days
The grill heating element is a 230-volt, 1500-watt radiant coil or surface element that generates intense direct heat for grilling or broiling food in your range or cooktop. It glows red-hot to sear and brown food from above or below depending on its position. Replace this element if it no longer heats up, heats unevenly, has visible breaks or burn spots, or causes your circuit to trip when in use.
This genuine OEM replacement part is a pulley assembly for dryers. Sometimes called an idler arm, the pulley assembly keeps the dryer drive belt under tension as the belt wraps around the dryer drum. If the dryer is no longer spinning properly and is making a lot of noise, the pulley assembly may need to be replaced. Luckily this repair is a relatively simple process.To remove the old dryer pulley assembly, start by making sure the dryer is unplugged. Remove the lint screen from the top of the dryer. Remove the two Phillips screws by the lint screen opening. Depress the clips that hold the top cover down. Lift the top cover and keep it in an upright position. Disconnect the wire harness to the switch that separates the connector. Remove the screws on the front panel. Lift the panel forward and set it to the side. Next, lift the drum and locate the pulley assembly under the drum. Lift the belt off the motor pulley to remove the assembly. Set the new pulley assembly in the same position as the old one and make sure everything is aligned. Rotate the drum to make sure it rotates smoothly. reinstall the panels.This replacement part is sold individually and is compatible with Bosch, Gaggenau, and Thermador dryers.