6621Jk2003b Parts

This handle pocket is the small insert that finishes the end of select appliance door handles and retains the KM 2.5-inch medallion. Replace a cracked or missing pocket to restore a secure hold and a clean, factory look.

• Retains the KM 2.5-in medallion at the handle end
• Provides a finished appearance and helps cover internal fasteners
• Helps keep the handle end secure to reduce looseness or rattles
• Typical symptoms: loose or missing medallion, cracked pocket, damaged/unfinished handle end

• Disconnect power to the appliance before servicing
• Access the handle end; remove any set screw(s) or trim as required
• Seat the new pocket, transfer the existing medallion, and resecure hardware
• Do not overtighten fasteners; verify the handle is secure and aligned

Replacement dishwasher dishrack for upper or lower rack position. Install when your existing rack is rusted, chipped, cracked, or broken. White finish.

Protective housing cap that encases the dishwasher thermostat. Replace if cracked, broken, or missing to properly shield temperature monitoring components.

Right-hand door hinge that restores proper door alignment and smooth operation. Replace if your dishwasher door sags, binds, or won't stay open. Verify fit.

Black control panel for dishwashers. Replaces cracked, faded, or damaged panels. Restores the front appearance of your dishwasher control area.

The Thermostat Clip is an OEM part for Whirlpool dishwashers. It plays an important supporting role by securely fastening the thermostat sensor inside the wash chamber. 

Symptoms of a faulty Thermostat Clip can include:

• Fluctuating or inconsistent water temperatures between cycles 
• Inability to properly detect temperature for desired heat levels
• Longer cycle times needed for reaching required temperatures
• Strange sounds or condensation around thermostat connection

Causes could arise from typical wear and tear stresses weakening plastic retaining clips. Exposure to harsh detergents may also erode clip material integrity over time.

This OEM replacement part is compatible with KitchenAid, Jenn-Air, Kenmore, and select Hotpoint and Roper dishwasher models as well. 

Replacement bracket that secures and supports internal dishwasher components. Install this support plate if your original is cracked, broken, or missing to restore alignment.

Secures the temperature sensor or thermostat to the dishwasher cabinet. Replace if the original bracket is cracked, broken, or missing hardware.

This lid is the washer's top cover that protects internal components and keeps clothes contained during operation. It restores the washer's enclosure and helps maintain safe, splash-free cycles. What it does:

• Covers the washer tub and control area to prevent splashes and keep items inside during cycles
• Provides the surface that the lid latch/switch engages to enable normal operation
• Replaces cracked, warped, or missing lids that allow debris in or interfere with closing
• Helps maintain the appliance's appearance and proper function of the top access

• Disconnect power before starting any repair to avoid electrical hazard
• Lift off or unbolt existing lid per your model's service instructions; alignment may be required for proper closure
• Keep screws and small parts organized; some models use hinge pins or clips that must be reinstalled
• If your washer also has a separate lid latch or switch, inspect and replace it only if listed as defective

Shield for dishwashers. Protects internal components from water and debris. Replace if cracked, broken, or missing to maintain proper coverage.

Secures hoses and prevents leaks at water or drain connections. Replace when clamps lose grip or hoses slip. Verify fit with your model number.

Outer bezel that holds the user interface and display. Replaces cracked, broken, or worn housings to restore a secure, finished front for the console.

Dispenser won't latch or close? This detergent dispenser releases soap at the right time. Moderate DIY repair requiring inner door panel removal.