Need Help?
Call
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Usually ships within 4 - 14 days
The Front Felt Glide Assembly is an OEM part for Frigidaire dryers. This part allows smooth operation of the dryer drum, providing a felt pad that the drum glides on as it rotates. This not only helps to support the drum but also minimizes friction and noise, contributing to the efficient and quiet operation of the dryer.
Over time, the felt portion of the glide assembly can wear down, leading to increased friction between the drum and the dryer's front panel.
Symptoms of a bad Front Felt Glide Assembly include:
This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.
Recommendations have fun and a bucket to prevent losing parts. First watch the videos, practice disassemble and reassemble the dryer drum. Make certain you have a good screw driver and spatula from kitchen (could not find my putty knife). Secondly, clean and inspect everything, make sure the motor bearing and belt pulleys are in good condition with little or no play. Third after you have confidently disassembled, vacuum cleaned, inspected all the worn parts, grease the motor and pulley,... Read more
A removable cap that covers the freezer's defrost drain hole, typically located at the bottom rear of the freezer compartment. Replace when water pools in the freezer, the cap is missing, or ice blocks the drainage system.
Replaced thermostat Read more
Replaced the dryer heater, and for good measure the limit and thermostat switches. My whole experience with Appliance Parts Pros was exceptional. I had a few questions to which the pros went out of there way to get the answers I needed. They also sent me the service manual which had step by step illustrations on how to disassemble the dryer. Saved a lot of time. Read more
The dryer timer power resistor regulates electrical current to the timer motor in mechanical timer systems. Replace when the timer fails to advance properly, gets stuck in cycles, or the dryer runs continuously without stopping.
Replaced the power resistor on the timer assembly. Solved the problem. Read more
The nylon slides on the front felt seal were worn out, allowing the drum to sag in the front. This is where our clothing would get caught and scorch. I replaced the felt, rear bearing kit and while I was that far, I replaced the belt as it's very inexpensive. All done for less than 10% of a new dryer purchase. Read more
Secures wiring harness to prevent chafing and maintain safe wire routing in washers, dryers, and laundry appliances. Replace if loose or broken. Check your model for compatibility.
By Frigidaire. Screen - 12-1/4" wide. Mounting frame included - 12-3/4" between mounting holes.
This adjustable leveling leg supports your dryer and allows you to level the appliance on uneven floors. It screws into the dryer's base and can be raised or lowered to eliminate rocking or vibration. Replace it when the leg is bent, stripped, or won't adjust properly, causing your dryer to be unstable or noisy.
Ordered new feet that fit unit. Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.