856543 Parts

The dishwasher dispenser grommet is a small rubber seal that prevents detergent and rinse aid from leaking around the dispenser mechanism in the door. Located where the dispenser cup meets the door panel, it maintains a watertight seal during wash cycles. Replace if detergent leaks from the dispenser area, the grommet is cracked or missing, or cleaning agents don't dispense properly.

This O-ring is a small rubber sealing gasket that prevents water leaks at a refrigerator water connection. It restores a watertight seal to stop drips and maintain proper water flow to the dispenser/ice system. What it does:

• Creates a watertight seal at a water line or valve connection
• Helps stop visible dripping or slow leaks from fittings
• Maintains proper pressure and flow by preventing bypass around a joint
• Used where a compressible seal is required between two mating parts

• Shut off water supply and disconnect power before servicing
• Replace only with the correct-size O-ring and seat it evenly in the groove
• Inspect mating surfaces for nicks or debris; clean before installing the new O-ring
• Tighten fittings to manufacturer torque recommendations to avoid over-compression

The door strike secures the dishwasher door in the closed position and activates safety switches during operation. Located on the dishwasher frame where the door latch engages, replace it if the door won't stay closed, won't latch properly, or the unit won't start despite being closed.

This replacement door gasket creates a tight seal around the refrigerator door to help maintain proper cooling and reduce energy waste. It restores the door's sealing surface for more consistent temperatures and less moisture buildup. What it does:

• Seals the door perimeter to keep cold air in and warm air out
• Helps prevent frost and ice buildup inside the compartment
• Reduces excessive run time from the compressor caused by air leaks
• Minimizes condensation and food spoilage linked to poor door sealing

• Disconnect power to the appliance before starting any work
• Remove the old gasket and clean the gasket channel and mounting surface
• Align and seat the new gasket evenly around the door; start at corners for best fit
• After installation, allow the gasket to set and check for gaps; adjust as needed